The use of acoustic panels is one of the most important methods for sound insulation in buildings. Moreover, it has become increasingly important to use green/natural origin materials in this area to reduce environmental impact. This study focuses on the investigation of acoustic, mechanical and thermal properties of natural fiber waste reinforced green epoxy composites. Three different types of fiber wastes were used, e.g., cotton, coconut and sugarcane with epoxy as the resin. Different fiber volume fractions, i.e., 10%, 15% and 20% for each fiber were used with a composite thickness of 3 mm. The sound absorption coefficient, impact strength, flexural strength, thermal conductivity, diffusivity, coefficient of thermal expansion and thermogravimetric properties of all samples were investigated. It has been found that by increasing the fiber content, the sound absorption coefficient also increases. The coconut fiber-based composites show a higher sound absorption coefficient than in the other fiber-reinforced composites. The impact and flexural strength of the cotton fiber-reinforced composite samples are higher than in other samples. The coefficient of thermal expansion of the cotton fiber-based composite is also higher than the other composites. Thermogravimetric analysis revealed that all the natural fiber-reinforced composites can sustain till 300 °C with a minor weight loss. The natural fiber-based composites can be used in building interiors, automotive body parts and household furniture. Such composite development is an ecofriendly approach to the acoustic world.

Abstract:Weld deposits are one of the most used economical ways of the wear resistance increase. The study compares the characteristics of the overlay material welded-on and the abrasive wear resistance. The research has been carried out using hardfacing alloys reinforced with primary chromium carbides and complex carbides. The overlay material was deposited on the low-carbon steel S235JR using the gas metal arc welding (GMAW) method. Four different commercial overlay materials were studied in terms of the microstructure effect. The abrasion wear testing was carried out using the abrasive cloth of grit 120 according to CSN 01 5084. The microstructure characterisation and surface analysis were made using optical and scanning electron microscopy. The results illustrate a significant effect of primary carbides on the abrasive wear resistance of weld deposits.

No abstract

No abstract

Abstract:Hardfacing is one of the most useful and economical ways to improve the performance of components submitted to severe wear conditions. This study has been made for the comparison of microstructure and abrasion resistance of hardfacing alloys reinforced with chromium carbides or complex carbides. The hardfacing alloys were deposited onto ČNS EN S235JR low carbon steel plates by the gas metal arc welding (GMAW) method. Different commercial hardfacing electrodes were applied to investigate the effect of abrasive particle size on abrasive wear resistance. The abrasion tests were made using the two-body abrasion test according to ČSN 01 5084 standard, abrasive cloths were of grits 80, 120, 240, and 400. Microstructure characterisation and surface analysis were made using optical and scanning electron microscopy. The results show the different influence of abrasive particles size on the wear rate for different structures of Fe-Cr-C system. The structures without primary carbides are of high abrasive wear rate, which increases nonlinearly with the increasing abrasive particle size. On the contrary, the structures containing primary carbides are of low abrasive rates and theses rates increase linearly with the increasing abrasive particle size.