ABSTRACT:Commercially available fourth and fifth generation poly(propyleneimine) (PPI) dendrimers were functionalized with acetyl chloride and deuterated acetyl chloride. Their solution properties in water and D 2 O were measured with dilution viscometry, densitometry, rheology, and small-angle neutron scattering (SANS) and compared to molecular modeling. Both the acetylated and PPI dendrimers exhibited Newtonian rheology in solution at all concentrations, but the functionalized dendrimers were less viscous than the nonacetylated dendrimers at an equal weight fraction (50 wt %). The acetylated dendrimers exhibited a pronounced structure peak in SANS, however, that was not evident for PPI in solution and a greatly enhanced solubility. This structure peak, evident at concentrations as low as 0.2 wt %, was evidence for long-range electrostatic interdendrimer forces, which were screened by added salt. A quantitative agreement was obtained between the dilute-limiting absolute scattering spectra of both the nonacetylated and acetylated dendrimers in solution with model calculations via a homogeneous spherical model and input parameters independently obtained from dilution viscometry or direct calculation. The combined measurements verified significant solvent penetration for both dendrimer types. The form factors measured in this manner were also in good quantitative agreement with the results of molecular dynamics simulations, which pointed to significant backfolding of the terminal groups. SANS and rheology measurements at higher concentrations suggested dendrimer clustering and interpenetration with increasing concentration, leading to less structure and lower viscosity than would be predicted from the dilute-limiting behavior.

A new thermodynamic model is derived that describes both loading and pulse-response behavior of proteins in hydrophobic interaction chromatography (HIC). The model describes adsorption in terms of protein and solvent activities, and water displacement from hydrophobic interfaces, and distinguishes contributions from ligand density, ligand type and protein species. Experimental isocratic response and loading data for a set of globular proteins on Sepharose™ resins of various ligand types and densities are described by the model with a limited number of parameters. The model is explicit in ligand density and may provide insight into the sensitivity of protein retention to ligand density in HIC as well as the limited reproducibility of HIC data.

A two-conformation, four-state model has been proposed to describe protein adsorption and unfolding behavior on hydrophobic interaction chromatography (HIC) resins. In this work, we build upon previous study and application of a four-state model to the effect of salt concentration on the adsorption and unfolding of the model protein alpha-lactalbumin in HIC. Contributions to the apparent adsorption strength of the wild-type protein from native and unfolded conformations, obtained using a deuterium labeling technique, reveal the free energy change and kinetics of unfolding on the resin, and demonstrate that surface unfolding is reversible. Additionally, variants of alpha-lactalbumin in which one of the disulfide bonds is reduced were synthesized to examine the effects of conformational stability on apparent retention. Below the melting temperatures of the wild-type protein and variants, reduction of a single disulfide bond significantly increases the apparent adsorption strength (approximately 6-8 kJ/mol) due to increased instability of the protein. Finally, the four-state model is used to accurately predict the apparent adsorption strength of a disulfide bond-reduced variant.

Hydrogen exchange has been a useful technique for studying the conformational state of proteins, both in bulk solution and at interfaces, for several decades. Here, we propose a physically-based model of simultaneous protein adsorption, unfolding and hydrogen exchange in HIC. An accompanying experimental protocol, utilizing mass spectrometry to quantify deuterium labeling, enables the determination of both the equilibrium partitioning between conformational states and pseudo-first order rate constants for folding and unfolding of adsorbed protein. Unlike chromatographic techniques, which rely on the interpretation of bulk phase behavior, this methodology utilizes the measurement of a molecular property (solvent exposure) and provides insight into the nature of the unfolded conformation in the adsorbed phase. Three model proteins of varying conformational stability, α-chymotrypsinogen A, β-lactoglobulin B, and holo α-lactalbumin, are studied on Sepharose ™ HIC resins possessing assorted ligand chemistries and densities. α-Chymotrypsinogen, the most conformationally stable protein in the set, exhibits no change in solvent exposure at all of the conditions studied, even when isocratic pulse-response chromatography suggests nearly irreversible adsorption. Apparent unfolding energies of adsorbed β-lactoglobulin B and holo α-lactalbumin range from −4 to 3 kJ/mol and are dependent on resin properties and salt concentration. Characteristic pseudo-first order rate constants for surfaceinduced unfolding are 0.2 to 0.9 min −1 . While poor protein recovery in HIC is often associated with irreversible unfolding, this study documents that non-eluting behavior can occur when surface unfolding is reversible or does not occur at all. Further, this hydrogen exchange technique can be used to assess the conformation of adsorbed protein under conditions where the protein is non-eluting and chromatographic methods are not applicable.