Areal 3D analysis of surface texture gives more opportunities than a study of 2D profiles. Surface topography evaluation, considered as 3D dimensional analysis in micro or nanoscales, plays an important role in many fields of science and life. Among many texture parameters, those connected with height are the most often used. However, there are many other parameters and functions that can provide additional important information regarding functional behaviour of surfaces in different applications. The knowledge about the functional importance of various surface properties is low. This review tries to fill this gap. Surface texture parameters are presented in various groups: height, spatial, hybrid, functional, feature, and others. Based on experiences of the present authors and literature review, the relationships among various surface parameters and functional properties are described. A proposal of a selection of parameters on the basis of their functional significations is provided. Considerations for future challenges are addressed.

No abstract

No abstract

This work is focused on the issue of non-measured points − one of the most important problems in surface texture measurements using optical methods. The fundamental aim of this research is to analyse errors of surface texture measurements caused by the presence of non-measured points. This study is divided into two parts. In the first part, circles with non-measured points were artificially created on peak portions of measured surfaces. In the second part − the results of measurement by a Talysurf CCI Lite interferometer were analysed. A measurement area of 3.3 × 3.3 mm contained 1024 × 1024 points. The measurements were performed with different intensity of light. Changes of parameters regarding the analysed errors depended on a surface type. The following parameters are susceptible to errors: skewness Ssk, areal material ratio Smr, as well as the following feature parameters: Spd, Sda, Sdv, Sha and Shv. Inaccuracies of measurement in valley parts of two-process textures led usually to larger errors of parameter computations compared with deviations in peak portions.

Wear tests were conducted using a pin-on-disc tester. In the experiment, a steel disc of hardness 40 HRC was put in contact with a steel pin of hardness 64 HRC with spherical end. Disc samples were prepared in order to obtain very similar values of the Sq parameter of one-process and two-process isotropic surfaces. Height of one–process disc surfaces, characterized by the Sq parameter was in the range 0.5 – 6 µm, but of two-process textures 1- 4.5 µm. Dry and lubricated tests, using different contact conditions were carried out. During testing, the friction force was monitored as a function of time. Wear of disc was measured after the test using white light interferometer. Tests under boundary lubrication condition were done using L-AN 46 oil.