This paper details the first implementation of a deep-set downhole hydraulic lubricator valve (DHLV) in Indonesia. This application was implemented in Jambaran field, onshore Central Java as part of Jambaran-Tiung Biru (JTB) national strategic project. Jambaran is a large carbonate gas field development located in proximity to densely populated areas. Since the field's reservoir contains significant concentrations of CO2 and H2S, it was important to design the completions to be able to perforate and test the wells safely without endangering the surrounding area. To produce as per reservoir management strategy, 800 ft of reservoir section drainage was required. Multiple completion designs were considered in the initial stages which included consideration of an open hole completions design, multiple wireline perforating runs and a cased hole live well single trip coiled tubing gun system. The rigless single trip coiled tubing gun deployment system was chosen due to safety and efficiency factors. With a deep set DHLV as the primary barrier in controlling the wells following perforating substantial daily rental cost savings can be realized during perforating operations. JTB field was developed by drilling 5 new well plus 1 re-entry well. The completions design was similar in all 6 wells. A 2 step completion design was utilized, to compensate for life of well tubing movement load, this consisted of a polished bore receptacle and production packer assembly in the lower completion. The 2nd stage of the completion consisted of 7" × 5-1/2" tubing with Tubing Retrievable Safety Valve (TRSV), DHLV, Permanent Downhole Gauge (PDHG) and production seal assembly. Strategically placing the PDHG below the DHLV enabled monitoring of bottom hole pressure during shut in without use of memory gauges validating the DHLV as primary barrier during gun retrieval. The production seal assembly was tied back into the lower polished bore receptacle that was previously set. The deep-set DHLV enabled the operator to (i) safely run long TCP gun assemblies up to 911 ft of gross gun length per well to perforate the whole well in 1 trip, (ii) POOH guns efficiently with one time bleed off (iii) efficiently initiate the pressure build up phase by shutting in the well against the DHLV as opposed to a surface valve prior to flowing the well and (iv) gun assemblies retrieved without the need to kill the well. After completing and well testing all 6 wells, the benefits of implementing the deep-set DHLV was immediately realized. By perforating underbalanced, omitting the well kill process and immediately proceeding with pressure build up by closing the DHLV resulted in operator savings of approximately 1.5 million USD over the entire rigless completion campaign.