Time domain reflectometry (TDR) has been developed to an operational level for the measurement of soil water content during the past decade. Because it is able to provide fast, precise and nondestructive in situ measurements, it has become an alternative to the neutron scattering method, in particular for monitoring water content under field conditions. One of the major disadvantages of the neutron scattering technique is that, due to the relatively high sensitivity of the signal to factors other than water content, site‐specific calibration is usually required. In this paper a calibration curve for the TDR method is presented which is not restricted to specific soil conditions. The calibration is based on the dielectric mixing model of Dobson et al. (1985). Measurements of volumetric water content and dielectric number at eleven different field sites representing a wide range of soil types were used to determine the parameter of the model by weighted nonlinear regression. The uncertainty (root mean square error) of water content values calculated with the optimized calibration curve was estimated not to exceed 0.013 cm3/cm3. This value is comparable to the precision of the thermogravimetric method. From a sensitivity analysis it was determined that the temperature dependence of the TDR signal may have to be corrected to obtain optimum accuracy.
Metal pollution of soils is widespread across the globe, and the clean up of these soils is a difficulttask. One possible remediation technique is ex-situ soil washing using chelating agents. Ethylenediaminetetraacetic acid (EDTA) is a very effective chelating agent for this purpose but has the disadvantage that it is quite persistent in the environment due to its low biodegradability. The aim of our work was to investigate the biodegradable chelating agents [S,S]-ethylenediaminedisuccinic acid (EDDS), iminodisuccinic acid (IDSA), methylglycine diacetic acid (MGDA), and nitrilotriacetic acid (NTA) as potential alternatives and compare them with EDTA for effectiveness. Kinetic experiments showed for all metals and soils that 24 h was the optimum extraction time. Longer times only gave minor additional benefits for heavy metal extraction but an unwanted increase in iron mobilization. For Cu at pH 7, the order of the extraction efficiency for equimolar ratios of chelating agent to metal was EDDS > NTA> IDSA > MGDA > EDTA and for Zn it was NTA > EDDS > EDTA >MGDA > IDSA. The comparatively low efficiency of EDTA resulted from competition between the heavy metals and co-extracted Ca. For Pb the order of extraction was EDTA > NTA >EDDS due to the much stronger complexation of Pb by EDTA compared to EDDS. At higher concentration of complexing agent, less difference between the agents was found and less pH dependence. There was an increase in heavy metal extraction with decreasing pH, but this was offset by an increase in Ca and Fe extraction. In sequential extractions EDDS extracted metals almost exclusively from the exchangeable, mobile, and Mn-oxide fractions. We conclude that the extraction with EDDS at pH 7 showed the best compromise between extraction efficiency for Cu, Zn, and Pb and loss of Ca and Fe from the soil.
In a field experiment we investigated the efficiency of two hyperaccumulating species, four agricultural crop plants, and one woody crop, at phytoextraction of Zn, Cd, and Cu from a polluted calcareous soil. In addition, we examined the possibility to enhance the phytoextraction of these metals by application of nitrilotriacetate (NTA) and elemental sulfur (S 8 ) to the soil. Metal uptake by hyperaccumulating species was higher than that by crop species but was generally low in all treatments compared to results reported in the literature, maybe as a result of lower total and available soil metal concentrations. Soil amended with either S 8 or NTA increased the solubility (NaNO 3 -extraction) of Zn, Cd, and Cu ions by factors of 21, 58, and 9, respectively, but plant accumulation of these metals was only increased by a factor of 2-3. As a result, even the highest metal removal rates achieved in this study were still far from what would be required to make this technique practicable for the remediation of the Dornach field site. To extract for example 50% of the total Cu, Zn, or Cd present in this soil within 10 years, plant metal concentrations of 10.000 mg kg -1 Cu or 10.000 mg kg -1 Zn or 45 mg kg -1 Cd would be required at a biomass production of 7.8 t ha -1 , or 10t ha -1 , or 10t ha -1 , respectively, assuming a linear decrease in soil metals.
Chelant-enhanced phytoextraction has received a lot of attention in the past decade. In theory, this technique could cleanse metal polluted soils by solubilizing contaminating metals, allowing them to be taken up by plants that would subsequently be removed from the site. We review the processes of metal solubilization, uptake by plants, and leaching during chelant-enhanced phytoextraction. A large excess of chelant is required to solubilize the target metal due to the co-solubilization of Ca and Fe. Chelated metals are taken up via the apoplastic pathway. Disruption of the Casparian Band is required to achieve the high shoot concentrations needed for phytoextraction. Therefore, adding chelants to a soil increases not only the total dissolved metal concentration but also changes the primary route of plant metal-uptake from the symplastic to the apoplastic pathway. Depending on metal, plant species, and chelant concentration, significant increases in metal uptake are likely. Soil solution chelate concentrations of at least several mM are required to induce appreciable shoot concentrations. A simple calculation reveals that at such soil solution concentrations plants will remove only a small fraction of the solubilized metals. Leaching, exacerbated by preferential flow processes, is unavoidable. Chelant-enhanced phytoextraction is therefore limited to areas where the connection with groundwater has been broken, orwhere leaching is unimportant. Chelant-enhanced phytoextraction may nonetheless have a role in enhancing the uptake of essential trace metals. Such a role warrants further investigations into the use of biodegradable chelants such as ethylenediaminedisuccinic acid (EDDS).
Abstract:Knowledge of the internal renewable water resources of a country is strategic information which is needed for long-term planning of a nation's water and food security, among many other needs. New modelling tools allow this quantification with high spatial and temporal resolution. In this study we used the program Soil and Water Assessment Tool (SWAT) in combination with the Sequential Uncertainty Fitting program (SUFI-2) to calibrate and validate a hydrologic model of Iran based on river discharges and wheat yield, taking into consideration dam operations and irrigation practices. Uncertainty analyses were also performed to assess the model performance. The results were quite satisfactory for most of the rivers across the country. We quantified all components of the water balance including blue water flow (water yield plus deep aquifer recharge), green water flow (actual and potential evapotranspiration) and green water storage (soil moisture) at sub-basin level with monthly time-steps. The spatially aggregated water resources and simulated yield compared well with the existing data. The study period was 1990-2002 for calibration and 1980-1989 for validation. The results show that irrigation practices have a significant impact on the water balances of the provinces with irrigated agriculture. Concerning the staple food crop in the country, 55% of irrigated wheat and 57% of rain-fed wheat are produced every year in water-scarce regions. The vulnerable situation of water resources availability has serious implications for the country's food security, and the looming impact of climate change could only worsen the situation. This study provides a strong basis for further studies concerning the water and food security and the water resources management strategies in the country and a unified approach for the analysis of blue and green water in other arid and semi-arid countries.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
customersupport@researchsolutions.com
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.