No abstract

A step-up for a non-isolated interleaved differential capacitor clamped boost (IDCCB) DC–DC converter is proposed in this manuscript. Because of its ability to produce high voltage gains, it is used in high-power applications. This converter’s modelling and control design are applicable to any number of phases. A six-phase interleaved differential capacitor clamped boost prototype is tested in this work, with an input voltage of 60 V, an output voltage of 360 V, and a nominal output power of 2.2 kW. The components of the converter are placed and controlled in such a way that the output voltage is the sum of the two capacitor voltages and the input voltage, which is two times higher than the supply voltage when compared to a conventional interleaved differential dual-boost converter. This converter reduces the stress on the capacitor with reference to the conventional interleaved differential boost converter for the same conversion gain. This prototype is considered and the developed approach is applied, after which the experimental results are obtained. This converter has potential for application in areas such as renewable energy conversion and electric vehicles.

In the case of microgrid (MG) systems, the choice of the right configuration plays a vital role to meet grid/load necessities when integrating low voltage, non-linear and highly sensitive (to environmental conditions) power sources such as solar PV modules, batteries and supercapacitors (SCs), etc. In the case of MG systems, the choice of the right configuration and the appropriate type of power converters in any application can have a significant impact on the optimum performance. Numerous architectures have been proposed for the integration of various energy sources to achieve optimum performance. A large number of research articles have been published in these areas. In this article, the detailed organization of various architectures based on the arrangement of various sources and detailed analyses is presented along with a discussion on those architectures. Moreover, the suitability of all the reviewed architectures based on driving factors such as (a) high conversion gain, (b) good power decoupling, (c) high efficiency, (d) isolation, (e) power-handling capabilities and (f) compact design is presented in the discussions section. The critical examination and comparative study presented in this work can assist both industry personnel and academicians in selecting the best architectural and power converter topologies required for optimum performance.

This article introduces a three-phase capacitor clamped inverter with inherent boost capability by relocating the filter components from the AC side to the configuration’s midpoint. This topology has several distinguishing characteristics, including: (a) low component count; (b) high DC-AC gain; (c) decreased capacitor voltage stresses; (d) improved power quality (extremely low voltage and current THDs) without the use of an AC-side filter; and (e) decreased voltage stresses on power semiconductor devices. Simulations were carried out on the MATLAB Simulink platform, and results under steady-state conditions, load and reference change conditions, and phase sequence change conditions, along with THD profiles, are presented. This inverter’s performance was compared to that of similar converters with intrinsic gain. A 1200 W experimental prototype was built to demonstrate the system’s feasibility and benefits. When compared to existing topologies, simulation and experimental results indicate that the proposed inverter provides superior high gain, smooth control, low stress, and a long life time.