Cataloged from PDF version of article.We describe a new, highly sensitive noncontact atomic force microscope/scanning tunneling microscope (STM) operating in ultrahigh vacuum (UHV) with subangstrom oscillation amplitudes for atomic resolution imaging and force-distance spectroscopy. A novel fiber interferometer with similar to4x10(-4) A/rootHz noise level is employed to detect cantilever displacements. Subangstrom oscillation amplitude is applied to the lever at a frequency well below the resonance and changes in the oscillation amplitude due to tip-sample force interactions are measured with a lock-in amplifier. Quantitative force gradient images can be obtained simultaneously with the STM topography. Employment of subangstrom oscillation amplitudes lets us perform force-distance measurements, which reveal very short-range force interactions, consistent with the theory. Performance of the microscope is demonstrated with quantitative atomic resolution images of Si(111)(7x7) and force-distance curves showing short interaction range, all obtained with <0.25 Angstrom lever oscillation amplitude. Our technique is not limited to UHV only and operation under liquids and air is feasible. (C) 2003 American Institute of Physics

Interatomic force gradients between a W tip and a 7 × 7 reconstructed Si(111) surface were measured using an off-resonance, ultra-low-amplitude atomic force microscope (AFM) technique. The amplitudes used were less than 1 Å (peak-to-peak), which allowed direct measurement of the interaction force gradients as a function of separation. The force gradient curves are shown to consist of an attractive van der Waals part and short-range attractive and repulsive interactions. The van der Waals background can be subtracted, leaving a short-range interaction with an energy parameter of 1.9-3.4 eV and an interaction length-scale of 0.54-1.26 Å, characteristic of a single atomic bond. This correlates well with our observation of single-atom resolved force gradient images. In general, the interaction is reversible up to the zero intercept of the force gradient (inflection point of the energy). Beyond this point hysteresis tends to be observed and the onset of inelastic deformation can be clearly discerned. An analysis of the atomic scale contact gives reasonable values for the interfacial energy, yield strength, and the energy per atom needed to initiate plastic deformation

Quantitative force gradient images are obtained using a sub-angström amplitude, off-resonance lever oscillation method during scanning tunneling microscopy imaging. We report the direct observation of short-range bonds, and the measured short-range force interaction agrees well in magnitude and length scale with theoretical predictions for single bonds. Atomic resolution is shown to be associated with the presence of a prominent short-range contribution to the total force interaction. It is shown that the background longer-range interaction, whose relative magnitude depends on the tip structure, has a significant effect on the contrast observed at the atomic scale. © 2001 American Institute of Physics

A new type of AFM is presented which allows for direct measurements of nanomechanical properties in ultra-high vacuum and liquid environments. The AFM is also capable of atomic-scale imaging of force gradients. This is achieved by vibrating a stiff lever at very small amplitudes of less than 1 Å (peak-to-peak) at a sub-resonance amplitude. This linearizes the measurement and makes the interpretation of the data straight-forward. At the atomic scale, interaction force gradients are measured which are consistent with the observation of single atomic bonds. Also, atomic scale damping is observed which rapidly rises with the tip-sample separation. A mechanism is proposed to explain this damping in terms of atomic relaxation in the tip. We also present recent results in water where we were able to measure the mechanical response due to the molecular ordering of water close to an atomically flat surface.

Dynamic Atomic Force Microscopy (AFM) is typically performed at amplitudes that are quite large compared to the measured interaction range. This complicates the data interpretation as measurements become highly non-linear. A new dynamic AFM technique in which ultra-small amplitudes are used (as low as 0.15 Angstrom) is able to linearize measurements of nanomechanical phenomena in ultra-high vacuum (UHV) and in liquids. Using this new technique we have measured single atom bonding, atomic-scale dissipation and molecular ordering in liquid layers, including water.