No abstract

No abstract

No abstract

This paper is presented in two parts. Part I (Tabular fluid properties for real gas analysis) describes an approach to creating a tabular representation of the equation of state that is applicable to any fluid. This approach is applied to generating an accurate and robust tabular representation of the RefProp CO2 properties. Part II (this paper) presents numerical simulations of a low flow coefficient supercritical CO2 centrifugal compressor developed for a closed loop power cycle. The real gas tables presented in part I are used in these simulations. Three operating conditions are simulated near the CO2 critical point: normal day (85 bar, 35C), hot day (105 bar, 50 C) and cold day (70 bar, 20C) conditions. The compressor is a single stage overhung design with shrouded impeller, 155 mm impeller tip diameter and a vaneless diffuser. An axial variable inlet guide vane (IGV) is used to control the incoming swirl into the impeller. An in-house three-dimensional computational fluid dynamics (CFD) solver named TACOMA is used with real gas tables for the steady flow simulations. The equilibrium thermodynamic modeling is used in this study. The real gas effects are important in the desired impeller operating range. It is observed that both the operating range (minimum and maximum volumetric flow rate) and the pressure ratio across the impeller are dependent on the inlet conditions. The compressor has nearly 25% higher operating range on a hot day as compared to the normal day conditions. A condensation region is observed near the impeller leading edge which grows as the compressor operating point moves towards choke. The impeller chokes near the mid-chord due to lower speed of sound in the liquid-vapor region resulting in a sharp drop near the choke side of the speedline. This behavior is explained by analyzing the 3D flow field within the impeller and thermodynamic quantities along the streamline. The 3D flow analysis for the flow near the critical point provides useful insight for the designers to modify the current compressor design for higher efficiency.

The operability of the axial compressor is generally limited by endwall flows; either at the casing mainly due to the tip leakage flows or at the hub mainly due to three-dimensional corner separations. Therefore, it is crucial to improve flows near the endwalls to enhance the operability of the compressor. Based on a last-stage with cantilevered stator vanes, a small endwall slot was introduced to a rotor blade to mitigate the hub corner separation and maximize the aerodynamic operating range of axial compressors by natural aspiration. The developed flow control technology is numerically analyzed based on the in-house High-Speed Research Compressor (HSRC) which, in turn, represents the rear stage of a modern compressor. This compressor was predicted to stall due to hub corner separation on a rotor blade based on multistage CFD analysis. A small spanwise endwall slot, connecting the pressure side and the suction side of a compressor rotor blade, was introduced near the hub to provide the by-pass flows from the pressure side to the suction side (see Figure 1). This naturally-aspirated jet significantly reduced the three-dimensional corner separation which generally occurs where the suction side meets the hub. The substantial reduction of the three-dimensional corner separation, in turn, improved the aerodynamic stall margin of the compressor. The benefit is accomplished because the low momentum region near the hub was energized due to the naturally-aspirated jet through the endwall slot and the radial migration of the low momentum flow on the suction side was significantly reduced. A systematic parametric study was conducted to better understand the flow details and optimize the flow control without sacrificing aerodynamic efficiency. It was discovered that a very small slot, smaller than 10% of span, located near the endwall, was sufficient to have a more than 6% improvement of the stall margin with a negligible efficiency penalty (less than 0.1%). The naturally-aspirated flow through the small slot eliminates the source of the corner separation at the hub platform by strengthening the flow near the hub. This, in turn, reduces the overall aerodynamic blockage by decreasing the radial migration of the low momentum flow over a third of the span. Finally, evaluations of the mechanical strength and structural dynamics of slotted rotor blades, as well as the aerodynamic impact in a multi-stage environment were conducted and its results were discussed.