In this study, the effects of sodium lauryl sulfate and various amino acids (DL-aspartic acid, dodecanedioic acid, and suberic acid) on the formation of calcium-deficient hydroxyapatite via hydrolysis of α-tricalcium phosphate (α-TCP) were investigated; moreover, a combined effect of these additives and ethylene glycol as a synthesis medium was also estimated. The hydrolysis reaction was performed in solutions containing different concentrations of additives in aqueous and mixed aqueous–organic media under solvothermal conditions. It was demonstrated that the nature and the concentration of organic additives influence the phase purity and morphology of the final product. Higher concentrations of sodium lauryl sulfate and dodecanedioic acid induced the formation of impurities in addition to hydroxyapatite, while aspartic and suberic acid did not affect the phase purity. The morphology of the samples varied from plate- to rod-like depending on the concentrations of specific organic additive.

In the present work, the effects of various organic solvents (solvent nature and fraction within the solution) and solvothermal conditions on the formation of calcium-deficient hydroxyapatite (CDHA) via hydrolysis of α-tricalcium phosphate (α-TCP) are investigated. The wet precipitation method is applied for α-TCP synthesis, and the hydrolysis reaction is performed in solutions with different water-to-organic solvent ratios under solvothermal conditions at 120 °C for 3 h and at 200 °C for 5 h. Ethyl alcohol, isopropyl alcohol, and butyl alcohol did not inhibit the hydrolysis of α-TCP, while methyl alcohol and ethylene glycol have a more prominent inhibitory effect on the hydrolysis, hence the formation of single-phased CDHA. From all the solvents analysed, ethylene glycol has the highest impact on the sample morphology. Under certain water to ethylene glycol ratios and solvothermal conditions, samples containing a significant fraction of rods are obtained. However, samples prepared with ethylene glycol are characterised by a particularly low BET surface area.

In this study, a low-temperature synthetic approach was developed for the fabrication of calcium hydroxyapatite (CHAp) coatings on a titanium substrate. The titanium substrates were first coated with CaCO3 by a spin-coating technique using a sol–gel chemistry approach, and the obtained product was transformed into CHAp during a dissolution–precipitation reaction. The phase purity and structural and morphological features of the obtained CHAp coatings were evaluated by X-ray diffraction (XRD) analysis, FTIR spectroscopy, Raman spectroscopy, scanning electron microscopy (SEM) and using a 3D optical profilometer. It was demonstrated that almost-single-phase CHAp formed on the titanium substrate with a negligible number of side phases, such as Na2HPO4 (starting material) and TiO2. In the Raman spectrum of the CHAp coating, the peaks of phosphate group vibrations were clearly seen. Thus, the obtained results of Raman spectroscopy correlated well with the results of X-ray diffraction analysis. The corrosive behaviour of CHAp coatings on a titanium substrate was also evaluated using electrochemical methods. It was found that the corrosion resistance of titanium coated with CHAp increased significantly. These CHAp thin films may be potential candidates for use in not only in regenerative medicine but also in the development of different sensors.