Permeability of the mineralized bone tissue is a critical element in understanding fluid flow occurring in the lacunar-canalicular porosity (PLC) compartment of bone and its role in bone nutrition and mechanotransduction. However, the estimation of bone permeability at the tissue level is affected by the influence of the vascular porosity (PV) in macroscopic samples containing several osteons. In this communication, both analytical and experimental approaches are proposed to estimate the lacunar-canalicular permeability in a single osteon. Data from an experimental stress-relaxation test in a single osteon is used to derive the PLC permeability by curve fitting to theoretical results from a compressible transverse isotropic poroelastic model of a porous annular disk under a ramp loading history (Cowin and Mehrabadi 2007;Gailani and Cowin 2008). The PLC tissue intrinsic permeability in the radial direction of the osteon was found to be dependent on the strain rate used and within the range of O(10 −24 )−O(10 −25 ). The reported values of PLC permeability are in reasonable agreement with previously reported values derived using FEA and nanoindentation approaches.

The influence of biomechanical stimuli on modulating cartilage homeostasis is well recognized. However, many aspects of cellular mechanotransduction in cartilage remain unknown. We developed a computer-controlled joint motion and loading system (JMLS) to study the biological response of cartilage under well-characterized mechanical loading environments. The JMLS was capable of controlling i) angular displacement, ii) motion frequency, iii) magnitude of the axial compressive load applied to the moving joint, and it featured real-time monitoring. The accuracy and repeatability of angular position measurements, the kinematic misalignment error as well as the repositioning error of the JMLS were evaluated. The effectiveness of the JMLS in implementing well-defined loading protocols such as moderate Passive Motion Loading (PML) and increased Compressive Motion Loading (CML) were tested. The JMLS demonstrated remarkable accuracy and reliability for the measurement and kinematics tests. Moreover, the effectiveness test demonstrated the ability of the JMLS to produce an effective stimulus via PML that led to the suppression of the catabolic effects of immobilization. Interestingly, the biological response of the CML group was catabolic and exhibited a pattern similar to that observed in the immobilization group. This novel system may be useful for joint biomechanics studies that require different treatment conditions of load and motion in vivo.

Determining the poroelastic properties of osteons is critical to better understand the role of fluid flow in the nutrition, mechanotransduction, remodeling, homeostasis and loss of bone. The permeability of single osteons is among the key properties that may influence these phenomena. The measurement of permeability of a single osteon remains one of the most demanding tasks in bone mechanics to be developed. Two associated challenges are the size of the osteon and the absence of appropriate tools and methods to perform such measurement. In this communication, we present the development of a new procedure to isolate osteons, the design of a mechanism for loading an osteon and the comparison of the stress relaxation test in unconfined compression experiment with the analytical results for a compressible transverse isotropy model that we previously reported in Gailani and Cowin [1]. These experimentally determined values of permeability and mechanical properties have shown reasonable agreement with the previously reported experimentally and theoretically estimated values.