The advent of laser cooling techniques revolutionized the study of many atomic-scale systems. This has fueled progress towards quantum computers by preparing trapped ions in their motional ground state [1], and generating new states of matter by achieving BoseEinstein condensation of atomic vapors [2]. Analogous cooling techniques [3, 4] provide a general and flexible method for preparing macroscopic objects in their motional ground state, bringing the powerful technology of micromechanics into the quantum regime. Cavity optoor electro-mechanical systems achieve sideband cooling through the strong interaction between light and motion [5][6][7][8][9][10][11][12][13][14][15]. However, entering the quantum regime, less than a single quantum of motion, has been elusive because sideband cooling has not sufficiently overwhelmed the coupling of mechanical systems to their hot environments. Here, we demonstrate sideband cooling of the motion of a micromechanical oscillator to the quantum ground state. Entering the quantum regime requires a large electromechanical interaction, which is achieved by embedding a micromechanical membrane into a superconducting microwave resonant circuit. In order to verify the cooling of the membrane motion into the quantum regime, we perform a near quantumlimited measurement of the microwave field, resolving this motion a factor of 5.1 from the Heisenberg limit [3]. Furthermore, our device exhibits strong-coupling allowing coherent exchange of microwave photons and mechanical phonons [16]. Simultaneously achieving strong coupling, ground state preparation and efficient measurement sets the stage for rapid advances in the control and detection of non-classical states of motion [17,18], possibly even testing quantum theory itself in the unexplored region of larger size and mass [19]. The universal ability to connect disparate physical systems through mechanical motion naturally leads towards future methods for engineering the coherent transfer of quantum information with widely different forms of quanta.Mechanical oscillators that are both decoupled from their environment (high quality factor Q) and placed in the quantum regime could allow us to explore quantum mechanics in entirely new ways [17][18][19][20][21]. For an oscillator to be in the quantum regime, it must be possible to prepare it in its ground state, to arbitrarily manipulate its quantum state, and to detect its state near the Heisenberg limit. In order to prepare an oscillator in its ground state, its temperature T must be reduced such that k B T < Ω m , where Ω m is the resonance frequency of the oscillator, k B is Boltzmann's constant, and is the reduced Planck's constant. While higher resonance frequency modes (> 1 GHz) can meet this cooling requirement with conventional refrigeration (T < 50 mK), these stiff oscillators are difficult to control and to detect within their short mechanical lifetimes. One unique approach using passive cooling has successfully overcome these difficulties by using a piezoelectric dilatation osci...

Demonstrating and exploiting the quantum nature of macroscopic mechanical objects would help us to investigate directly the limitations of quantum-based measurements and quantum information protocols, as well as to test long-standing questions about macroscopic quantum coherence. Central to this effort is the necessity of long-lived mechanical states. Previous efforts have witnessed quantum behaviour, but for a low-quality-factor mechanical system. The field of cavity optomechanics and electromechanics, in which a high-quality-factor mechanical oscillator is parametrically coupled to an electromagnetic cavity resonance, provides a practical architecture for cooling, manipulation and detection of motion at the quantum level. One requirement is strong coupling, in which the interaction between the two systems is faster than the dissipation of energy from either system. Here, by incorporating a free-standing, flexible aluminium membrane into a lumped-element superconducting resonant cavity, we have increased the single-photon coupling strength between these two systems by more than two orders of magnitude, compared to previously obtained coupling strengths. A parametric drive tone at the difference frequency between the mechanical oscillator and the cavity resonance dramatically increases the overall coupling strength, allowing us to completely enter the quantum-enabled, strong-coupling regime. This is evidenced by a maximum normal-mode splitting of nearly six bare cavity linewidths. Spectroscopic measurements of these 'dressed states' are in excellent quantitative agreement with recent theoretical predictions. The basic circuit architecture presented here provides a feasible path to ground-state cooling and subsequent coherent control and measurement of long-lived quantum states of mechanical motion.

Dielectric loss from two-level states is shown to be a dominant decoherence source in superconducting quantum bits. Depending on the qubit design, dielectric loss from insulating materials or the tunnel junction can lead to short coherence times. We show that a variety of microwave and qubit measurements are well modeled by loss from resonant absorption of two-level defects. Our results demonstrate that this loss can be significantly reduced by using better dielectrics and fabricating junctions of small area . With a redesigned phase qubit employing low-loss dielectrics, the energy relaxation rate has been improved by a factor of 20, opening up the possibility of multiqubit gates and algorithms.

Converting low-frequency electrical signals into much higher frequency optical signals has enabled modern communications networks to leverage both the strengths of microfabricated electrical circuits and optical fiber transmission, allowing information networks to grow in size and complexity. A microwave-to-optical converter in a quantum information network could provide similar gains by linking quantum processors via low-loss optical fibers and enabling a large-scale quantum network. However, no current technology can convert low-frequency microwave signals into high-frequency optical signals while preserving their fragile quantum state. For this demanding application, a converter must provide a near-unitary transformation between different frequencies; that is, the ideal transformation is reversible, coherent, and lossless. Here we demonstrate a converter that reversibly, coherently, and efficiently links the microwave and optical portions of the electromagnetic spectrum. We use our converter to transfer classical signals between microwave and optical light with conversion efficiencies of ∼10%, and achieve performance sufficient to transfer quantum states if the device were further precooled from its current 4 kelvin operating temperature to below 40 millikelvin. The converter uses a mechanically compliant membrane to interface optical light with superconducting microwave circuitry, and this unique combination of technologies may provide a way to link distant nodes of a quantum information network. IntroductionModern communication networks manipulate information at several gigahertz with microprocessors and distribute information at hundreds of terahertz via optical fibers. A similar frequency dichotomy is developing in quantum information processing. Superconducting qubits operating at several gigahertz have recently emerged as promising high-fidelity and intrinsically scalable quantum processors [1][2][3]. Conversely, optical frequencies provide access to low-loss transmission [4] and long-lived quantum-compatible storage [5,6]. Converting information between gigahertz-frequency "microwave light" that can be deftly manipulated and terahertzfrequency "optical light" that can be efficiently distributed will enable small-scale quantum systems [7][8][9] to be combined into larger, fully-functional quantum networks [10,11]. But no current technology can transform information between these vastly different frequencies while preserving the fragile quantum state of the information. For this demanding application, a frequency converter must provide a near-unitary transformation between microwave light and optical light; that is, the ideal transformation is reversible, coherent, and lossless.Certain nonlinear materials provide a link between microwave and optical light, and these are commonly used in electro-optic modulators (EOMs) for just this purpose. While EOMs might be capable of reversible frequency conversion [12,13], such conversion has not yet been demonstrated, and even optimized EOMs [14,15] have predicted ...

When two physical systems share the quantum property of entanglement, measurements of one system appear to determine the state of the other. This peculiar property is used in optical, atomic, and electrical systems in an effort to exceed classical bounds when processing information. We extended the domain of this quantum resource by entangling the motion of a macroscopic mechanical oscillator with a propagating electrical signal and by storing one half of the entangled state in the mechanical oscillator. This result demonstrates an essential requirement for using compact and low-loss micromechanical oscillators in a quantum processor, can be extended to sense forces beyond the standard quantum limit, and may enable tests of quantum theory.