We report a new hybrid integration scheme that offers for the first time a nanowire-on-lead approach, which enables independent electrical addressability, is scalable, and has superior spatial resolution in vertical nanowire arrays. The fabrication of these nanowire arrays is demonstrated to be scalable down to submicrometer site-to-site spacing and can be combined with standard integrated circuit fabrication technologies. We utilize these arrays to perform electrophysiological recordings from mouse and rat primary neurons and human induced pluripotent stem cell (hiPSC)-derived neurons, which revealed high signal-to-noise ratios and sensitivity to subthreshold postsynaptic potentials (PSPs). We measured electrical activity from rodent neurons from 8 days in vitro (DIV) to 14 DIV and from hiPSC-derived neurons at 6 weeks in vitro post culture with signal amplitudes up to 99 mV. Overall, our platform paves the way for longitudinal electrophysiological experiments on synaptic activity in human iPSC based disease models of neuronal networks, critical for understanding the mechanisms of neurological diseases and for developing drugs to treat them.

The electrosynthesis of valuable multicarbon chemicals using carbon dioxide (CO 2 ) as a feedstock has substantially progressed recently but still faces considerable challenges. A major difficulty lines in the sluggish kinetics of forming carbon−carbon (C−C) bonds, especially in neutral media. We report here that oxide-derived copper crystals enclosed by six {100} and eight {111} facets can reduce CO 2 to multicarbon products with a high Faradaic efficiency of 74.9 ± 1.7% at a commercially relevant current density of 300 mA cm −2 in 1 M KHCO 3 (pH ∼ 8.4). By combining the experimental and computational studies, we uncovered that Cu(100)/Cu(111) interfaces offer a favorable local electronic structure that enhances *CO adsorption and lowers C−C coupling activation energy barriers, performing superior to Cu(100) and Cu(111) surfaces, respectively. On this catalyst, no obvious degradation was observed at 300 mA cm −2 over 50 h of continuous operation.

Optimizing the electronic structures and carrier dynamics in semiconductors at atomic scale is an essential issue for innovative device applications. Besides the traditional chemical doping and the use of homo/heterostructures, elastic strain has been proposed as a promising possibility. Here, we report on the direct observation of the dynamics of exciton transport in a ZnO microwire under pure elastic bending deformation, by using cathodoluminescence with high temporal, spatial, and energy resolutions. We demonstrate that excitons can be effectively drifted by the strain gradient in inhomogeneous strain fields. Our observations are well reproduced by a drift-diffusion model taking into account the strain gradient and allow us to deduce an exciton mobility of 1400 ( 100 cm 2 /(eV s) in the ZnO wire. These results propose a way to tune the exciton dynamics in semiconductors and imply the possible role of strain gradient in optoelectronic and sensing nano/microdevices.

architecture, diversity, and electrophysiology of the human brain at early stages. [7,8] Brain organoids thus provide a reliable and easily accessible platform to study human brain development and neurodevelopmental diseases, [9][10][11][12] bridging the gap between animal research and human clinical study.However, long-term stable recording of single-cell electrophysiology in developing brain organoids is still a challenge. The recording technology not only needs to form minimally invasive and long-term stable electrical interfaces with individual neurons 3D distributed across brain organoids but also needs to accommodate the rapid volume change occurring during the organoid organogenesis and cortical expansion. Optical imaging coupled with fluorescence dyes [13] or calcium indicators [14] has been used to visualize the neuron activities in 3D. They, however, are limited by temporal resolution, penetration depth, and long-term signal stability. Electrical measurement techniques such as 2D multielectrode arrays (MEA) [15,16] and patch-clamp [17,18] have been applied to measure the functional development of brain organoids, but they can only capture the activities from the bottom surface of brain organoids [1,19,20] or assay one cell at a time with cell membrane disruption. The recent development of 3D bioelectronics enables 3D interfaces with brain organoids. [21][22][23][24][25][26][27] However, they either only contact organoids at the surface by flexible electronics, [21][22][23] where noncorrelated and 3D-distributed single-unit action potentials cannot be recorded, or penetrate organoids invasively by rigid probes, [25] which cannot further accommodate volume and morphological changes of brain organoids during development. It has also been shown that organoids can grow around a suspended array of electrodes, [26,27] but the electrodes cannot deform to adapt to the morphological changes of the organoid. To date, it is still a challenge to noninvasively probe neuron activity at single-cell, single-spike spatiotemporal resolution across the 3D volume of brain organoids, and over the time course of development. This constraint prevents further understanding of the functional development in brain organoids and standardizing culture conditions and protocols for brain organoid generation based on their electrical functions.Recently, we developed a cyborg organoid platform by integrating "tissue-like" stretchable mesh nanoelectronics with 2D stem cell sheets. Leveraging the 2D-to-3D reconfiguration Human induced pluripotent stem cell derived brain organoids have shown great potential for studies of human brain development and neurological disorders. However, quantifying the evolution of the electrical properties of brain organoids during development is currently limited by the measurement techniques, which cannot provide long-term stable 3D bioelectrical interfaces with developing brain organoids. Here, a cyborg brain organoid platform is reported, in which "tissue-like" stretchable mesh nanoelectronics are designed...

Detailed information regarding the alloy deposition/ dealloying and fabrication steps, the energy dispersive X-ray spectral characterization, histology on chronically implanted mice and characterization of explanted electrodes, electrochemical impedance spectroscopy and their small signal components, sterilization effects of autoclave, ethylene oxide, and sterrad, on impedance distribution, comparison of surface and depth recorded single units and extracted composite receptive fields in songbird experiments, and comparison of recordings using PtNR devices and NeuroNexus ECoG Pt electrodes on NHP and corresponding power-frequency plots (PDF)