Rates of performing work that engender a sustained lactic acidosis evidence a slow component of pulmonary O2 uptake (VO2) kinetics. This slow component delays or obviates the attainment of a stable VO2 and elevates VO2 above that predicted from considerations of work rate. The mechanistic basis for this slow component is obscure. Competing hypotheses depend on its origin within either the exercising limbs or the rest of the body. To resolve this question, six healthy males performed light nonfatiguing [approximately 50% maximal O2 uptake (VO2max)] and severe fatiguing cycle ergometry, and simultaneous measurements were made of pulmonary VO2 and leg blood flow by thermodilution. Blood was sampled 1) from the femoral vein for O2 and CO2 pressures and O2 content, lactate, pH, epinephrine, norepinephrine, and potassium concentrations, and temperature and 2) from the radial artery for O2 and CO2 pressures, O2 content, lactate concentration, and pH. Two-leg VO2 was thus calculated as the product of 2 X blood flow and arteriovenous O2 difference. Blood pressure was measured in the radial artery and femoral vein. During light exercise, both pulmonary and leg VO2 remained stable from minute 3 to the end of exercise (26 min). In contrast, during severe exercise [295 +/- 10 (SE) W], pulmonary VO2 increased 19.8 +/- 2.4% (P less than 0.05) from minute 3 to fatigue (occurring on average at 20.8 min). Over the same period, leg VO2 increased by 24.2 +/- 5.2% (P less than 0.05). Increases of leg and pulmonary VO2 were highly correlated (r = 0.911), and augmented leg VO2 could account for 86% of the rise in pulmonary VO2.(ABSTRACT TRUNCATED AT 250 WORDS)

In the mammalian lung, alveolar gas and blood are separated by an extremely thin membrane, despite the fact that mechanical failure could be catastrophic for gas exchange. We raised the pulmonary capillary pressure in anesthetized rabbits until stress failure occurred. At capillary transmural pressures greater than or equal to 40 mmHg, disruption of the capillary endothelium and alveolar epithelium was seen in some locations. The three principal forces acting on the capillary wall were analyzed. 1) Circumferential wall tension caused by the transmural pressure. This is approximately 25 dyn/cm (25 mN/m) at failure where the radius of curvature of the capillary is 5 microns. This tension is small, being comparable with the tension in the alveolar wall associated with lung elastic recoil. 2) Surface tension of the alveolar lining layer. This contributes support to the capillaries that bulge into the alveolar spaces at these high pressures. When protein leakage into the alveolar spaces occurs because of stress failure, the increase in surface tension caused by surfactant inhibition could be a powerful force preventing further failure. 3) Tension of the tissue elements in the alveolar wall associated with lung inflation. This may be negligible at normal lung volumes but considerable at high volumes. Whereas circumferential wall tension is low, capillary wall stress at failure is very high at approximately 8 x 10(5) dyn/cm2 (8 x 10(4) N/m2) where the thickness is only 0.3 microns. This is approximately the same as the wall stress of the normal aorta, which is predominantly composed of collagen and elastin. The strength of the thin part of the capillary wall is probably attributable to the collagen IV of the basement membranes. The safety factor is apparently small when the capillary pressure is raised during heavy exercise. Stress failure causes increased permeability with protein leakage, or frank hemorrhage, and probably has a role in several types of lung disease.

To provide clinical diagnostic criteria for pulmonary embolism (PE), we evaluated 750 consecutive patients with suspected PE who were enrolled in the Prospective Investigative Study of Acute Pulmonary Embolism Diagnosis (PISA-PED). Prior to perfusion lung scanning, patients were examined independently by six pulmonologists according to a standardized diagnostic protocol. Study design required pulmonary angiography in all patients with abnormal scans. Patients are reported as two distinct groups: a first group of 500, whose data were analyzed to derive a clinical diagnostic algorithm for PE, and a second group of 250 in whom the diagnostic algorithm was validated. PE was diagnosed by angiography in 202 (40%) of the 500 patients in the first group. A diagnostic algorithm was developed that includes the identification of three symptoms (sudden onset dyspnea, chest pain, and fainting) and their association with one or more of the following abnormalities: electrocardiographic signs of right ventricular overload, radiographic signs of oligemia, amputation of hilar artery, and pulmonary consolidations compatible with infarction. The above three symptoms (singly or in some combination) were associated with at least one of the above electrocardiographic and radiographic abnormalities in 164 (81%) of 202 patients with confirmed PE and in only 22 (7%) of 298 patients without PE. The rate of correct clinical classification was 88% (440/500). In the validation group of 250 patients the prevalence of PE was 42% (104/250). In this group, the sensitivity and specificity of the clinical diagnostic algorithm for PE were 84% (95% CI: 77 to 91%) and 95% (95% CI: 91 to 99%), respectively. The rate of correct clinical classification was 90% (225/250). Combining clinical estimates of PE, derived from the diagnostic algorithm, with independent interpretation of perfusion lung scans helps restrict the need for angiography to a minority of patients with suspected PE.

To assess the value of perfusion lung scan in the diagnosis of pulmonary embolism, we prospectively evaluated 890 consecutive patients with suspected pulmonary embolism. Prior to lung scanning, each patient was assigned a clinical probability of pulmonary embolism (very likely, possible, unlikely). Perfusion scans were independently classified as follows: (1) normal, (2) near-normal, (3) abnormal compatible with pulmonary embolism (PE+: single or multiple wedge-shaped perfusion defects), or (4) abnormal not compatible with pulmonary embolism (PE-: perfusion defects other than wedge-shaped). The study design required pulmonary angiography and clinical and scintigraphic follow-up in all patients with abnormal scans. Of 890 scans, 220 were classified as normal/or near-normal and 670 as abnormal. A definitive diagnosis was established in 563 (84%) patients with abnormal scans. The overall prevalence of pulmonary embolism was 39%. Most patients with angiographically proven pulmonary embolism had PE+ scans (sensitivity: 92%). Conversely, most patients without emboli on angiography had PE- scans (specificity: 87%). A PE+ scan associated with a very likely or possible clinical presentation of pulmonary embolism had positive predictive values of 99 and 92%, respectively. A PE- scan paired with an unlikely clinical presentation had a negative predictive value of 97%. Clinical assessment combined with perfusion-scan evaluation established or excluded pulmonary embolism in the majority of patients with abnormal scans. Our data indicate that accurate diagnosis of pulmonary embolism is possible by perfusion scanning alone, without ventilation imaging. Combining perfusion scanning with clinical assessment helps to restrict the need for angiography to a minority of patients with suspected pulmonary embolism.

We previously showed that when pulmonary capillaries in anesthetized rabbits are exposed to a transmural pressure (Ptm) of approximately 40 mmHg, stress failure of the walls occurs with disruption of the capillary endothelium, alveolar epithelium, or sometimes all layers. The present study was designed to test whether stress failure occurred more frequently at high than at low lung volumes for the same Ptm. Lungs of anesthetized rabbits were inflated to a transpulmonary pressure of 20 cmH2O, perfused with autologous blood at 32.5 or 2.5 cmH2O Ptm, and fixed by intravascular perfusion. Samples were examined by both transmission and scanning electron microscopy. The results were compared with those of a previous study in which the lung was inflated to a transpulmonary pressure of 5 cmH2O. There was a large increase in the frequency of stress failure of the capillary walls at the higher lung volume. For example, at 32.5 cmH2O Ptm, the number of endothelial breaks per millimeter cell lining was 7.1 +/- 2.2 at the high lung volume compared with 0.7 +/- 0.4 at the low lung volume. The corresponding values for epithelium were 8.5 +/- 1.6 and 0.9 +/- 0.6. Both differences were significant (P less than 0.05). At 52.5 cmH2O Ptm, the results for endothelium were 20.7 +/- 7.6 (high volume) and 7.1 +/- 2.1 (low volume), and the corresponding results for epithelium were 32.8 +/- 11.9 and 11.4 +/- 3.7. At 32.5 cmH2O Ptm, the thickness of the blood-gas barrier was greater at the higher lung volume, consistent with the development of more interstitial edema. Ballooning of the epithelium caused by accumulation of edema fluid between the epithelial cell and its basement membrane was seen at 32.5 and 52.5 cmH2O Ptm. At high lung volume, the breaks tended to be narrower and fewer were oriented perpendicular to the axis of the pulmonary capillaries than at low lung volumes. Transmission and scanning electron microscopy measurements agreed well. Our findings provide a physiological mechanism for other studies showing increased capillary permeability at high states of lung inflation.