Briefly describes a technique that permits esterification with diazomethane and rapid extraction in a single step.

Measurements in the infrared region using semiconductor lasers, particularly as applied to atmospheric pollution monitoring, depend critically on the availability of reliable line positions and linewidth information. We demonstrate a unique internal calibration technique such that spectral locations can be determined accurately, to the order of the monochromaticity of the laser. This is based on low-pressure absorption measurements and subsequent fitting of a Voigt profile and determining the Doppler component. With this technique, we are able to determine the self- and the N2-broadening parameters of the NH3 line at 852.7 cm−1 to be 26.2 ± 0.4 MHz Torr−1 and 5.2 ± 0.1 MHz Torr−1, respectively. Also, the spectral locations for several SO2 lines in the 1180.1 cm−1 region were determined accurately.

No abstract

This material was produced from a microfilm copy of the original document. While the most advanced technological means to photograph and reproduce this document have been used, the quality Is heavily dependent upon the quality of the original submitted. The following explanation of techniques is provided to help you understand markings or patterns which may appear on this reproduction. 1.The sign or "target" for pages apparently lacking from the document photographed is "Missing Page(s)". If it was possible to obtain the missing page(s) or section, they are spliced into the film along with adjacent pages. This may have necessitated cutting thru an image and duplicating adjacent pages to insure you complete continuity. 2. When an image on the film is obliterated with a large round black mark, it is an indication that the photographer suspected that the copy may have moved during exposure and thus cause a blurred image. You will find a good image of the page in the adjacent frame. 3. When a map, drawing or chart, etc., was part of the material being photographed the photographer followed a definite method in "sectioning" the material. It is customary to begin photoing at the upper left hand corner of a large sheet and to continue photoing from left to right in equal sections with a small overlap. If necessary, sectioning is continued again-beginning below the first row and continuing on until complete. 4. The majority of users indicate that the textual content is of greatest value, however, a somewhat higher quality reproduction could be made from "photographs" if essential to the understanding of the dissertation. Sihrer prints of "photographs" may be ordered at additional charge by writing the Order Department, giving the catalog number, title, author and specific pages you wish reproduced. 5. PLEASE NOTE: Some pages may have indistinct print. Filmed as received.