No abstract

The need for flexible power generation is growing worldwide as the energy transition is altering the operational regimes of thermal power plants. Plasma ignition systems, as an alternative technology to the conventional start-up method with natural gas or oil firing, offer a cost- and energy-efficient start-up process in pulverized fuel power stations. The application of plasma ignition systems for cold start-ups using different qualities of pre-dried lignite is investigated in a pilot-scale combustion facility. A plasma integrated swirl burner is developed and validated using highly ignitable lignite dust. Eight pre-dried lignite qualities with a moisture content of up to 30% and a broad particle size distribution are investigated for this application to determine the applicability and limitations of the plasma ignition system with regard to the fuel quality. The performance of lignites for cold start-up in the plasma ignition system are categorized based on their ignition and combustion performance. All lignite qualities were ignited under the cold-start-up condition with a plasma power of 4 kW to 7 kW. Lignite qualities with a moisture content of up to 20% and a median particle size of below 450 μm form a self-sustained flame with short-time plasma-supported combustion, while flame blow-out is observed for lignites with lower qualities.

The ignition characteristics of coal dust is of high importance for the flame stability in coal-fired power plants. We investigate the ignitability of six lignite dust qualities and one hard coal using dust explosion tests and an ignitability characteristic number. The paper aims to identify the degree of impact of the properties of coals, such as the moisture content, the ash content etc., on the ignition characteristics and ultimately to compare the identified relevant ignition parameters to the ignition performance of the dust qualities in an industrially relevant environment. The minimum cloud ignition temperature (MCIT), the maximum rate of pressure rise ((dp/dt)max), the maximum explosion pressure (pmax), the deflagration index (Kst-value) and the modified ignitability characteristic number (ZWZmod.) were determined and were attributed to the moisture content, the ash content and the median particle size. The MCIT was largely influenced by the volatile content, whereas the variations of moisture and ash contents within the range of 10% to 20% did not have a significant impact on the MCIT. The maximum explosion pressure did not differ considerably and stayed in a narrow range among the tested dust qualities. The deflagration index showed a higher sensitivity to the dust properties. The deflagration index and the modified ignitability characteristics number dropped as the moisture content increased and the volatile content reduced. The Kst and ZWZmod. values showed the highest susceptibility to the coal dust properties. Hence, they were used as representative parameters for further comparison with the ignition performance of coal dust in a pilot-scale testing. The results showed that both parameters predicted the ignition performance relatively well and can be used as indicators for the prediction of the ignition performance.

No abstract