Gas turbines for power generation are optimised to run with fossil fuels but as a response to tighter pollutant regulations and to enable the use of renewable fuels there is a great interest in improving fuel flexibility. One interesting renewable fuel is syngas from biomass gasification but its properties vary depending on the feedstock and gasification principle, and are significantly different from conventional fuels. This paper aims to give an overview of the differences in combustion behaviour by comparing numerical solutions with methane and several different synthesis gas compositions. The TECFLAM swirl burner geometry, which is designed to be representative of common gas turbine burners, was selected for comparison. The advantage with this geometry is that detailed experimental measurements with methane are publicly available. A two-stage approach was employed with development and validation of an advanced CFD model against experimental data for methane combustion followed by simulations with four syngas mixtures. The validated model was used to compare the flame shape and other characteristics of the flow between methane, 40% hydrogen enriched methane and four typical syngas compositions. It was found that the syngas cases experience lower swirl intensity due to high axial velocities that weakens the inner recirculation zone. Moreover, the higher laminar flame speed of the syngas cases has a strong effect on the flame front shape by bending it away from the axial direction, by making it shorter and by increasing the curvature of the flame front. A hypothesis that the flame shape and position is primarily governed by the laminar flame speed is supported by the almost identical flame shapes for bark powder syngas and 40% hydrogen enriched methane. These gas mixtures have almost identical laminar flame speeds for the relevant equivalence ratios but the heating value of the syngas is more than a factor of 3 smaller than that of the hydrogen enriched methane. The syngas compositions used are representative of practical gasification processes and biomass feedstocks. The demonstrated strong correlation between laminar flame speed and flame shape could be used as a rule of thumb to quickly judge whether the flame might come in contact with the structure or in other ways be detrimental to the function of the combustion system.