This paper presents the reformation and fabrication resolved on the wire clamp and top plate (WCTP) design to eliminate the presence of lead finger bouncing resulting to high rejection of non-stick on leads (NSOL). Problem experienced was that the hollow or half-etched portion of the leadframe at the top and bottom units caused its bouncing effect. With the aim to improve localized massive NSOL defect, WCTP has been modified to provide positive bias to support its hollow part or the half-etched part of the leadframe at the top and bottom of the units. The re-designed WCTP was fabricated, extending its clamping with enhanced vacuum on top and bottom rows. The implementation of the improved WCTP design reduced the defect with 88 % improvement with the defect reduction during the lot runs.

Semiconductor assembly mass production environment has means of testing and verifying bond consistency and reliability during wire bonding. Common bond integrity assessment is ball shear testing (BST). This test enables analysis of the strength between the bond pad and a ball bond. This paper presents significant procedure on how ball shear testing parameters should be treated during wirebond integrity check. Device complexity in terms of performing ball shear testing specifically on sensor dice has different output responses. Frequent shearing on die resulted as bond pads are elevated by 30 µm (microns). To address manufacturing in-process controls challenges, shearing tool position, dage settings, and optical scopes are taken into consideration. Also, a study was performed on the execution correctness in combination with proper dage parameters was explored to meet good ball shear test process capability and break modes.