In this article, we report only 10 atomic layer thick, high mobility, transparent thin film transistors (TFTs) with ambipolar device characteristics fabricated on both a conventional silicon platform as well as on a flexible substrate. Monolayer graphene was used as metal electrodes, 3-4 atomic layers of h-BN were used as the gate dielectric, and finally bilayers of WSe2 were used as the semiconducting channel material for the TFTs. The field effect carrier mobility was extracted to be 45 cm(2)/(V s), which exceeds the mobility values of state of the art amorphous silicon based TFTs by ∼100 times. The active device stack of WSe2-hBN-graphene was found to be more than 88% transparent over the entire visible spectrum and the device characteristics were unaltered for in-plane mechanical strain of up to 2%. The device demonstrated remarkable temperature stability over 77-400 K. Low contact resistance value of 1.4 kΩ-μm, subthreshold slope of 90 mv/decade, current ON-OFF ratio of 10(7), and presence of both electron and hole conduction were observed in our all two-dimensional (2D) TFTs, which are extremely desirable but rarely reported characteristics of most of the organic and inorganic TFTs. To the best of our knowledge, this is the first report of all 2D transparent TFT fabricated on flexible substrate along with the highest mobility and current ON-OFF ratio.

Carboxylic functionalization (-COOH groups) of carbon nanotubes is known to improve their dispersion properties and increase the electrical conductivity of carbon-nanotubepolymer nanocomposites. We have studied experimentally the effects of this type of functionalization on the thermal conductivity of the nanocomposites. It was found that while even small quantities of carbon nanotubes (~1 wt%) can increase the electrical conductivity, a larger loading fraction (~3 wt%) is required to enhance the thermal conductivity of nanocomposites. Functionalized multi-wall carbon nanotubes performed the best as filler material leading to a simultaneous improvement of the electrical and thermal properties of the composites. Functionalization of the single-wall carbon nanotubes reduced the thermal conductivity enhancement. The observed trends were explained by the fact that while surface functionalization increases the coupling between carbon nanotube and polymer matrix it also leads to formation of defects, which impede the acoustic phonon transport in the single wall carbon nanotubes. The obtained results are important for applications of carbon nanotubes and graphene flakes as fillers for improving thermal, electrical and mechanical properties of composites.

No abstract