In this investigation a range of ketone biofuels produced from the alkylation of isoamyl alcohol and isobutanol were examined as potential blending agents with Jet A-1 aviation kerosene. The fuels were synthesised under solvent-free conditions using a Pd/C catalyst with K3PO4, previously reported for the alkylation of acetone, butanol, ethanol (ABE) fermentation mixtures. Reasonable yields and selectivity were achieved for branched alkylation products with up to 61 % produced from isoamyl alcohol and 64 % from isobutanol. The key aviation fuel properties of the mixtures were tested unblended and in 50% and 20% blends with Jet A-1 aviation kerosene. The freezing point of the fuels were all found to be below the required-47 °C irrespective of blend or the temperature of the reaction. The energy density of the unblended fuels ranged between 30.4-41.36 MJ/kg depending on the temperature of the reaction and whether remaining alcohols were removed. While this is below the HHV of the Jet A-1 used (45.69 MJ/kg) the energy density of the 50% and 20% blends were more suitable with the isoamyl alcohol derived fuels having a maximum HHV of 44.31 MJ/kg at 50% blending and 44.99 MJ/kg at 20% blend with Jet A-1. The fuels derived from isoamyl alcohol produced above 140 °C were found to satisfy the flash point criterion (>38 °C) of the Jet A-1 specification, though the isobutanol derived fuels did not, producing fuels with flash points between 33 °C and 35 °C. The kinematic viscosity of the fuels were also tested at-20 °C. Unblended only a few of the fuels analysed met the maximum viscosity requirement at-20 °C of 8 mm 2 s-1 , though this fuel property was improved substantially on blending with jet fuel. This work demonstrates that ketones produced from isoamyl alcohol through a simple alkylation have the potential to be used as blending agents with Jet A-1.

No abstract