This study determined the difference in rate of degradation between pure polymers of lactic acid (pla), glycolic acid (PGA), and various ratios of copolymers of these two substances. Fast-cured and slow-cured polyglycolide was compared with copolymers of glycolide/lactide intermixed in ratios of 75:25, 50:50, and 25:75, as well as pure polylactide. A total of 420 rats were implanted with carbon-14 and tritium-labeled polymers in bone and soft tissue. At intervals of 1, 2, 3, 5, 7, 9, and 11 months, groups of five animals with the implants in bone and five with the implants in the abdominal wall were sacrificed. The implant area as well as tissue from the liver, spleen, kidney, lung and some muscle tissue was analyzed for radioactivity along with the urine and feces collected throughout the experiment. Half-lives of the different polymers and copolymers were calculated from the radioactivity present in the implant area for each time interval. Half-life of the polymers and copolymers decreased from 5 months for 100% PGA to 1 week with 50:50 PGA:PLA copolymer and rapidly increased to 6.1 months for 100% PLA. Fast-cured PGA had a half-life in tissue of 0.85 months. No difference in rate of degradation was seen in soft tissue or bone. No significant radioactivity was detected in urine, feces, or tissue samples. From this study, it is concluded that control of degradation rate of the implant could best be attained by varying the composition of PLA and PGA between 75% and 100% PLA along with a corresponding 25% to 0% PGA. This would provide a half-life range of the implant of from 2 weeks to 6 months.
Current state‐of‐the‐art environmental barrier coatings (EBCs) for Si‐based ceramics consist of three layers: a silicon bond coat, an intermediate mullite (3Al2O3·2SiO2) or mullite + BSAS ((1−x)BaO·xSrO·Al2O3·2SiO2, 0 ≤x≤ 1) layer, and a BSAS top coat. Areas of concern for long‐term durability are environmental durability, chemical compatibility, volatility, phase stability, and thermal conductivity. Variants of this family of EBC were applied onto monolithic SiC and melt‐infiltrated SiC/SiC composites. Reaction between BSAS and silica results in a low‐melting (∼1300°C) glass, which can cause the spallation of the EBC. At temperatures greater than ∼1400°C BSAS suffers significant recession via volatilization in water‐vapor‐containing atmospheres. Both reactions can be EBC life‐limiting factors. BSAS undergoes a very sluggish phase transformation (hexagonal celsian to monoclinic celsian), the implications of which are not fully understood at this point. Initial rapid increase in thermal conductivity at temperatures as low as 1300°C indicates the sintering of EBC.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.