No abstract

Prior to the formation of the Red Sea the northeastern Afro/Arabian continent had low relief and was largely below sea level from the Late Cretaceous to the early Oligocene. The events leading to the formation of the Red Sea followed the sequence (1) alkaline volcanism and rifting beginning about 30–32 Ma affecting a narrow linear zone in the continent, (2) rotational block faulting and detachment faulting, well underway by 25 Ma, (3) gabbro and diorite magmatism, andesite to rhyolite volcanism, and fine‐grained nonmarine sedimentation in the rift between 20 and 25 Ma, (4) fine‐grained marine sedimentation in the rift as the early shelves started to subside in the middle Miocene, and (5) uplift of the adjacent continents (about 3 km) and subsidence of the shelves (about 4 km) between 13.8 and 5 Ma. The youth of the uplift is suggested by 44 fission track dates on apatites from rocks of the Proterozoic Arabian Shield that range in age from 13.8 to 568 Ma. The youngest of these ages, coupled with the present high relief along the Arabian escarpment and published heat flow measurements, indicate that 2.5–4 km uplift has occurred in the last 13.8 m.y. The sequence volcanism/rifting followed by uplift leads to our adoption of a passive mantle model for rift origin. Models that require uplift to create the rift are rejected, because of the late uplift. We advocate a model of lithospheric extension caused by two‐dimensional plate stress over those requiring tractional drag at the base of the lithosphere caused by vigorous flow in the asthenosphere. It is acknowledged that traction models could explain the observed data, but they imply a rigid, static lithosphere and seem to require a link between the direction of flow in the asthenosphere and plate motions. Neither requirement is necessary in the extension model. The rift starts with mechanical extension in a narrow zone of lithosphere between 25–32 Ma in our model. The thinned lithosphere is replaced by upwelling asthenosphere and by rocks from the adjacent deep continental lithosphere which flow into the rift. Ductile flow of the deep continental lithosphere is accelerated by partial melting as rocks flow upward toward the rift axis. Once partially melted, rocks formerly part of the continental lithosphere join the upwelling asthenosphere, resulting in a rapid erosion of the lithospheric mantle beneath the continent near the rift edge. The resulting density decrease explains the uplift. We think that the Red Sea began as a consequence of changing plate geometries resulting from the collision of India and Eurasia. After the collision, the segment of the Owens fracture zone north of the Carlsberg Ridge became locked, forcing the northeast corner of Afro/Arabia to rotate with the Indian plate away from the rest of Africa.

No abstract

The Pacific plate moved northwest relative to North America since 42 Ma. The rapid half rate of Pacific-Farallon spreading allowed the ridge to approach the continent at about 29 Ma. Extinct spreading ridges that occur offshore along 65% of the margin (Lonsdale, 1991) document that fragments of the subducted Farallon slab became captured by the Pacific plate and assumed its motion prior to the actual subduction of the spreading ridge. This platecapture process can be used to explain much of the post-29 Ma Cordilleran North America extension, strike slip, and the inland jump of oceanic spreading in the Gulf of California. The Pacific and North American contact zone lengthened with each successive plate capture event, underpinning the parts of western North America directly inland with a strong plate undergoing Pacific relative motion. We suggest that much of the post-29 Ma continental tectonism is the result of the strong traction imposed on the deep part of the continental crust by the gently inclined slab of subducted oceanic lithosphere as it moved to the northwest relative to the overlying continent. The platecapture hypothesis is distinctly different from theories involving shallow slab gaps. Kinematic problems associated with shallow slab-gap models cause us to question them. This conclusion is consistent with seismic refraction interpretations that suggest there is an inclined layer with high velocities like that of basalt or gabbro at the base of the continental crust beneath much of the Californian margin and the documented reduction of slab-pull forces and density associated with young subducting slabs. Thermal and rheologic modeling suggests that coastal California was a strong zone at all depths allowing it to be firmly linked to Pacific motion. Our model shows that deformed regions such as the basin and range and borderland provinces developed in predicted weak parts of the crustal section, but they have been incompletely linked to the deep plate across the ductile middle and lower crustal layer.

No abstract