A method is developed to enable emulsion polymerization to be performed under RAFT control to give living character without the problems that often affect such systems:  formation of an oily layer, loss of colloidal stability, or loss of molecular weight control. Trithiocarbonate RAFT agents are used to form short stabilizing blocks from a water-soluble monomer, from which diblocks can be created by the subsequent polymerization of a hydrophobic monomer. These diblocks are designed to self-assemble to form micelles. Polymerization is initially performed under conditions that avoid the presence of monomer droplets during the particle formation stage and until the hydrophobic ends of the diblocks have become sufficiently long to prevent them from desorbing from the newly formed particles. Polymerization is then continued at any desired feed rate and composition of monomer. The polymer forming in the reaction remains under RAFT control throughout the polymerization; molecular weight polydispersities are generally low. The number of RAFT-ended chains within a particle is much larger than the aggregation number at which the original micelles would have self-assembled, implying that in the early stages of the polymerization, there is aggregation of the micelles and/or migration of the diblocks. The latexes resulting from this approach are stabilized by anchored blocks of the hydrophilic monomer, e.g., acrylic acid, with no labile surfactant present. Sequential polymerization of two hydrophobic monomers gives completely novel core−shell particles where most chains extend from the core of the particles through the shell layer to the surface.

Eight persons from five institutions in different countries carried out polymerizations of aniline following the same preparation protocol. In a "standard" procedure, aniline hydrochloride was oxidized with ammonium peroxydisulfate in aqueous medium at ambient temperature. The yield of polyaniline was higher than 90 % in all cases. The electrical conductivity of polyaniline hydrochloride thus prepared was 4.4 ± 1.7 S cm-1 (average of 59 samples), measured at room temperature. A product with defined electrical properties could be obtained in various laboratories by following the same synthetic procedure. The influence of reduced reaction temperature and increased acidity of the polymerization medium on polyaniline conductivity were also addressed. The conductivity changes occurring during the storage of polyaniline were monitored. The density of polyaniline hydrochloride was 1.329 g cm-3. The average conductivity of corresponding polyaniline bases was 1.4 x10­8 S cm-1, the density being 1.245 g cm-1. Additional changes in the conductivity take place during storage. Aging is more pronounced in powders than in compressed samples. As far as aging effects are concerned, their assessment is relative. The observed reduction in the conductivity by ~10 % after more than one-year storage is large but, compared with the low conductivity of corresponding polyaniline (PANI) base, such a change is negligible. For most applications, an acceptable level of conductivity may be maintained throughout the expected lifetime.

SUMMARYPulsed-laser polymerization (PLP) in conjugation with molecular weight distribution (MWD) measurement has emerged as the method of choice for determining the propagation rate coefficient k, in free-radical polymerizations. Detailed guidelines for using this technique (including essential internal consistency checks) and reporting the results therefrom are given by the authors, members of the IUPAC Working Party on Modeling of kinetics and processes of polymerization. The results for PLP-MWD k, measurements from many laboratories for bulk free-radical polymerization of styrene at low conversions and ambient pressure are collated, and are in excellent agreement. They are therefore recommended as constituting a benchmark data set, one that is best fitted by (the confidence ellipsoid for the Arrhenius parameters is also given). These benchmark data are also used to evaluate the merits of several other methods for determining k,; it is found that appropriately calibrated electron paramagnetic resonance spectroscopy appears to yield reliable values of k, for styrene.

No abstract