No abstract

No abstract

This paper develops a magnetic equivalent circuit model suitable to the design and optimization of the synchronous ac homopolar machine. The ac homopolar machine is of particular interest in the application of grid-based flywheel energy storage, where it has the potential to significantly reduce self-discharge associated with magnetic losses. The ac homopolar machine features both axial and radial magnetizing flux paths, which requires finite element analysis to be conducted in 3-D. The computation time associated with 3-D finite element modeling is highly prohibitive in the design process. The magnetic equivalent circuit model developed in this paper is shown to be a viable alternative for calculating several design performance parameters and has a computation time which is orders of magnitude less than that of 3-D finite element analysis. Results obtained from the developed model are shown to be in good agreement with finite element and experimental results for varying levels of saturation.Index Terms-Energy storage, finite element analysis, flywheels, magnetic equivalent circuit (MEC), renewable generation. ;).R. Nilssen and T. Undeland are with the Department of Electric Power Engineering,

In this paper, the influence of slot harmonics on magnetic forces and vibration is studied in a 120-slot/116-pole low-speed PM machine at no-load. It is shown how the lowest mode of vibration is produced at no-load due to slotting. Comparing the cases of open slots, semi-closed slots and magnetic wedges, the effect of slot closure on radial forces and torque production capability is discussed. Magnetic flux distribution in the airgap is computed using finite element analysis. Spatial harmonics due to slotting are investigated in different cases. Maxwell's stress tensor is employed to calculate radial and tangential components of the force density in the airgap. Spatial distribution of the total forces on the teeth and also time-dependent force waveform on one tooth are analyzed and discussed for different cases. It is shown how the magnitude of the lowest mode of vibration is reduced in the case of using semi-closed slots and magnetic wedges. Tangential force density distribution and torque production capability are also discussed. Structural analysis is presented to compute the maximum amplitude of the stator deformations due to the radial forces. Experimental results of the prototype generator are presented verifying the existence of the lowest mode of vibration at no-load because of the slot harmonics.

No abstract