No abstract

No abstract

This paper documents the elastic deformations and corresponding aerodynamic coefficients of flexible wings used for micro air vehicles (MAVs). These lowaspect ratio wings, developed and fabricated at the University of Florida, incorporate an elastic latex membrane skin covering a thin carbon fiber skeleton. The wings were tested in a unique low-speed wind tunnel facility integrating a visual image correlation (VIC) system with a six-component strain gauge sting balance. Model characteristics are presented, along with the appropriate specimen preparation techniques and wind tunnel instrumentation. The static response characteristics, including full-field displacements and plane strain measurements, for three distinct MAV wing designs are presented. The full-field deformation results show how passive wing flexibility preferably affects aerodynamic performance when compared to a rigid model of similar geometry.

No abstract

A low aspect ratio, low Reynolds number membrane wing has been identified as a viable platform for micro air vehicle applications. Desirable flying qualities include high lift and larger stability margins. Several challenges are associated with the numerical modeling of such a wing, including highly three-dimensional flows, separation bubbles, and nonlinear membrane behavior. A thorough model validation and system identification effort is therefore required. A novel experimental setup integrates a wind tunnel with a visual image correlation system, for simultaneous measurement of wing displacements, strains, and aerodynamic loads. These three metrics are used for a direct comparison of numerical and experimental data for both pre-and post-stall angles of attack. Suitable correspondence is demonstrated for moderate angles of attack; methods for increasing the model fidelity can be made for angles with poor predictive capability. Computed flow structures reveal further information concerning the aeroelastic behavior of membrane wings.