No abstract

Advances in L-band microwave satellite radiometry in the past decade, pioneered by ESA's SMOS and NASA's Aquarius and SMAP missions, have demonstrated an unprecedented capability to observe global sea surface salinity (SSS) from space. Measurements from these missions are the only means to probe the very-near surface salinity (top cm), providing a unique monitoring capability for the interfacial exchanges of water between the atmosphere and the upper-ocean, and delivering a wealth of information on various salinity processes in the ocean, linkages with the climate and water cycle, including land-sea connections, and providing constraints for ocean prediction models. The satellite SSS data are complimentary to the existing in situ systems such as Argo that provide accurate depiction of large-scale salinity variability in the open ocean but under-sample mesoscale variability, coastal oceans and marginal seas, and energetic regions such as boundary currents and fronts. In particular, salinity remote sensing has proven valuable to systematically monitor the open oceans as well as coastal regions up to approximately 40 km from the coasts. This is critical to addressing societally relevant topics, such as land-sea linkages, coastal-open ocean exchanges, research in the carbon cycle, near-surface mixing, and air-sea exchange of gas and mass. In this paper, we provide a community perspective on the major achievements of satellite SSS for the aforementioned topics, the unique capability of satellite salinity observing system and its complementarity with other platforms, uncertainty characteristics of satellite SSS, and measurement versus sampling errors in relation to in situ salinity measurements. We also discuss the need for technological innovations to improve the accuracy, resolution, and coverage of satellite SSS, and the way forward to both continue and enhance salinity remote sensing as part of the integrated Earth Observing System in order to address societal needs.

Abstract-Sea surface salinity can be measured by microwave radiometry at L-band (1400-1427 MHz). This frequency is a compromise between sensitivity to the salinity, small atmospheric perturbation, and reasonable pixel resolution. The description of the ocean emission depends on two main factors: 1) the sea water permittivity, which is a function of salinity, temperature, and frequency, and 2) the sea surface state, which depends on the wind-induced wave spectrum, swell, and rain-induced roughness spectrum, and by the foam coverage and its emissivity. This study presents a simplified two-layer emission model for foam-covered water and the results of a controlled experiment to measure the foam emissivity as a function of salinity, foam thickness, incidence angle, and polarization. Experimental results are presented, and then compared to the two-layer foam emission model with the measured foam parameters used as input model parameters. At 37 psu salt water the foam-induced emissivity increase is 0.007 per millimeter of foam thickness (extrapolated to nadir), increasing with increasing incidence angles at vertical polarization, and decreasing with increasing incidence angles at horizontal polarization.

International audienceSoil Moisture and Ocean Salinity (SMOS), launched on 2 November 2009, is the first satellite mission addressing sea surface salinity (SSS) measurement from space. Its unique payload is the Microwave Imaging Radiometer using Aperture Synthesis (MIRAS), a new two-dimensional interferometer designed by the European Space Agency (ESA) and operating at the L-band frequency. This article presents a summary of SSS retrieval from SMOS observations and shows initial results obtained one year after launch. These results are encouraging, but also indicate that further improvements at various data processing levels are needed and hence are currently under investigation

An analysis is presented for the spatial and intensity distributions of North Atlantic extreme atmospheric events crossing the buoyant Amazon-Orinoco freshwater plume. The sea surface cooling amplitude in the wake of an ensemble of storm tracks traveling in that region is estimated from satellite products for the period 1998-2012. For the most intense storms, cooling is systematically reduced by 50% over the plume area compared to surroundings open-ocean waters. Historical salinity and temperature observations from in situ profiles indicate that salt-driven vertical stratification, enhanced oceanic heat content, and barrier-layer presence within the plume waters are likely key oceanic factors to explain these results. Satellite SMOS surface salinity data combined with in situ observations are further used to detail the oceanic response to category 4 hurricane Igor in 2010. Argo and satellite measurements confirm the haline stratification impact on the cooling inhibition as the hurricane crossed the river plume. Over this region, the SSS mapping capability is further tested and demonstrated to monitor the horizontal distribution of the vertical stratification parameter. SMOS SSS data can thus be used to consistently anticipate the cooling inhibition in the wake of TCs traveling over the Amazon-Orinoco plume region.