Ta3N5 nanostructures are widely explored as anodes for photoelectrochemical (PEC) water splitting. Although the material shows excellent semiconductive properties for this purpose, the key challenge is its severe photocorrosion when used in typical aqueous environments. In the present work we introduce a NiFe layered double hydroxide (LDH) cocatalyst that dramatically reduces photocorrosion effects. To fabricate the Ta3N5 electrode, we use through-template anodization of Ta and obtain oxide nanorod arrays that then are converted to Ta3N5 by high temperature nitridation. After modification with our cocatalyst system, we obtained solar photocurrents of 6.3 mA cm–2 at 1.23 VRHE in 1 M KOH, and an electrode maintains about 80% of the initial activity for extended irradiation times.

Hematite, α-Fe2O3, is considered as one of the most promising materials for sustainable hydrogen production via photoelectrochemical water splitting with a theoretical solar-to-hydrogen efficiency of 17%. However, the poor electrical conductivity of hematite is a substantial limitation reducing its efficiency in real experimental conditions. Despite of computing models suggesting that the electrical conductivity is extremely anisotropic, revealing up to 4 orders of magnitude higher electron transport with conduction along the (110) hematite crystal plane, synthetic approaches allowing the sole growth in that direction have not been reported yet. Here, we present a strategy for controlling the crystal orientation of very thin hematite films by adjusting energy of ion flux during advanced pulsed reactive magnetron sputtering technique. The texture and effect of the deposition mode on the film properties were monitored by XRD, conversion electron Mössbauer spectroscopy, XPS, SEM, AFM, PEC water splitting, IPCE, transient photocurrent measurements, and Mott-Schottky analysis. The precise control of the synthetic conditions allowed to fabricate hematite photoanodes exhibiting fully textured structures along (110) and (104) crystal planes with huge differences in photocurrents of 0.65 and 0.02 mA cm(-2) (both at 1.55 V versus RHE), respectively. The photocurrent registered for fully textured (110) film is among record values reported for thin planar films. Moreover, the developed fine-tuning of crystal orientation having a huge impact on the photoefficiency would induce further improvement of thin hematite films mainly if cation doping will be combined with the controllable texture.

No abstract

Host-guest systems such as hematite/SnO2 have attracted a great deal of interest as photoanodes for photoelectrochemical water splitting. In the present work we form an ordered porous tin oxide layer formed by self-organizing anodization of Sn films on a FTO substrate. Subsequently the anodic tin oxide nanostructure is doped with antimony (ATO) by a simple impregnation and annealing treatment, and then decorated with hematite using anodic deposition. Photoelectrochemical water splitting experiments show that compared to conventional SnO2 nanostructures, using a Sb doped nanochannel SnO2 as a host leads to a drastic increase of the water splitting photocurrent response up to 1.5 mA cm(-2) at 1.6 V (vs. RHE) in 1 M KOH under AM 1.5 (100 mW cm(-2) ) conditions compared to 0.04 mA cm(-2) for the non-Sb doped SnO2 scaffold.

We introduce the use of pure molten ortho-phosphoric acid (o-H3PO4) as an electrolyte for self-organizing electrochemistry. This electrolyte allows for the formation of self-organized oxide architectures (one-dimensional nanotubes, nanochannels, nanopores) on metals such as tungsten that up to now were regarded as very difficult to grow self-ordered anodic oxide structures. In this work, we show particularly the fabrication of thick, vertically aligned tungsten oxide nanochannel layers, with pore diameter of ca. 10 nm and illustrate their potential use in some typical applications.