No abstract

Much attention has been paid to developing effective visible light catalytic technologies for VOC oxidation without requiring extra energy. In this paper, a series of sponge-based catalysts with rich three-dimensional porosity are synthesized by combining MnOx and graphitic carbon nitride (GCN) with commercial melamine sponges (MS) coated with polydopamine (PDA), demonstrating excellent photothermal catalytic performance for formaldehyde (HCHO). The three-dimensional porous framework of MS can provide a good surface for material modification and a reliable interface for gas-solid interaction. The grown layer of PDA framework not only increases the near-infrared wavelength absorption for improving the light-to-heat conversion of catalysts, but also brings excellent adhesion for the subsequent addition of MnOX and GCN. The efficient formaldehyde oxidation is attributed to the sufficient oxygen vacancies generated by co-loaded MnOX and GCN, which is conducive to the activation of more O2− in the oxidation process. As the surface temperature of catalyst rapidly increases to its maximum value at ca. 115 °C under visible light irradiation, the HCHO concentration drops from 160 ppm to 46 ppm within 20 min. The reaction mechanism is certified as a classical Mars-van Krevelen mechanism based on the photo-induced thermal catalysis process.

Tribocatalysis, as a new approach in environmental purification, has drawn increasing attention in the past few years. In this work, we successfully convert mechanical energy to chemical energy by Bi12TiO20, which was synthesized by a hydrothermal method. Under magnetic stirring, electrons transfer from the surface of Bi12TiO20 to the polytetrafluoroethylene-sealed magnetic bar due to their friction. Moreover, the holes that remain on Bi12TiO20 provide oxidation properties in the process for organic matter degradation. According to a series of tests, it is noticed that the shape of the stirring bar and the material of the reaction vessel have a remarkable influence on the removal efficiency of contaminants. Simultaneously, multiple tests reveal the high stability of Bi12TiO20. A great potential for Bi12TiO20 to control water pollutants under dark conditions during collection of ambient mechanical energy was clearly demonstrated in this study.

Volatile organic compounds (VOCs) exert a serious impact on the environment and human health. The development of new technologies for the elimination of VOCs, especially those from non-industrial emission sources, such as indoor air pollution and other low-concentration VOCs exhaust gases, is essential for improving environmental quality and human health. In this study, a monolithic photothermocatalyst was prepared by stabilizing manganese oxide on multi-porous carbon spheres to facilitate the elimination of formaldehyde (HCHO). This catalyst exhibited excellent photothermal synergistic performance. Therefore, by harvesting only visible light, the catalyst could spontaneously heat up its surface to achieve a thermal catalytic oxidation state suitable for eliminating HCHO. We found that the surface temperature of the catalyst could reach to up 93.8 °C under visible light, achieving an 87.5% HCHO removal efficiency when the initial concentration of HCHO was 160 ppm. The microporous structure on the surface of the carbon spheres not only increased the specific surface area and loading capacity of manganese oxide but also increased their photothermal efficiency, allowing them to reach a temperature high enough for MnOx to overcome the activation energy required for HCHO oxidation. The relevant catalyst characteristics were analyzed using XRD, measurement of BET surface area, scanning electron microscopy, HR-TEM, XPS, and DRS. Results obtained from a cyclic performance test indicated high stability and potential application of the MnOx-modified multi-porous carbon sphere.

No abstract