Optical switching has the potential to scale the capacity of data center networks (DCN) with a simultaneously reduction in latency and power consumption. One of the main challenges of optically-switched DCNs is the need for fast clock and data recovery (CDR). Because the DCN traffic is dominated by small packets, the CDR locking time is required to be less than one nanosecond for achieving high network throughput. This need for sub-nanosecond CDR locking time has motivated research on optical clock synchronization techniques, which deliver synchronized clock signals through optical fibers such that the CDR modules in each transceiver only need to track the slow change of clock phase, due to change of the time of flight as temperature varies. It is desired to remove the need for clock phase tracking (and thereby the CDR modules) if the temperatureinduced clock phase drift can be significantly reduced, which would reduce the power consumption and the cost of transceivers. Previous studies have shown that the temperature-induced skew change between multi-core fiber (MCF) cores can be forty times lower than that of standard single mode fibers. Thus, clock-synchronized transmission maybe possible by using two different MCF cores for clock and data transmission, respectively, enabling the sharing of an optical clock with stable clock phase. To investigate the potential of MCF for CDR-free short-reach communications, we first improve the measurement method of the temperature dependent inter-core skew change by using a modified delay interferometer, achieving a resolution of 3.8 femtoseconds for accurate inter-core skew measurements. Building on the MCF measurement results, we carried out an MCF-based clock-synchronized transmission experiment, demonstrating the feasibility of CDR-free data communications over a temperature range of 43 • C that meets DCN requirements. Index Terms-Data center networks, clock synchronization, Multi-core fiber, Thermal coefficient of delay.

Originally developed for metrology, optical frequency combs are becoming increasingly pervasive in a wider range of research topics including optical communications, spectroscopy, and radio or microwave signal processing. However, application demands in these fields can be more challenging as they require compact sources with a high tolerance to temperature variations that are capable of delivering flat comb spectra, high power per tone, narrow linewidth and high optical signal-to-noise ratio. This work reports the generation of a flat, high power frequency comb in the telecom band using a 17 mm fully-integrated silicon core fibre as a parametric mixer. Our all-fibre, cavity-free source combines the material benefits of planar waveguide structures with the advantageous properties of fibre platforms to achieve a 30 nm bandwidth comb source containing 143 tones with <3 kHz linewidth, 12 dB flatness, and >30 dB OSNR over the entire spectral region.

We design and optimize a parametric frequency comb generator using all polarization- maintaining components, highly-doped PM fiber and PM highly-nonlinear fibers, obtaining 500 tones over 100nm with >-5dBm per tone and less than 40kHz linewidth.

A pump dithering removal algorithm, based on pilot sequence-aided DSP, is proposed and experimentally validated in dual polarization 64 QAM optical phase conjugation system. A 4.2 dB SNR improvement was observed due to the SBS suppression.

A cost-effective scan technique enabling scalable measurement range is presented by injecting a sweep RF signal of 27.5-30 GHz into an electro-optic comb generator. The 10 th -order harmonic scans over an extended span where an ultra-narrow (Q >10 6 ) resonance is well-resolved with sub-MHz resolution.