Welding generates complex metal fumes that vary in composition. The objectives of this study were to compare the persistence of deposited metals and the inflammatory potential of stainless and mild steel welding fumes, the two most common fumes used in US industry. Sprague-Dawley rats were exposed to 40 mg/m(3) of stainless or mild steel welding fumes for 3 h/day for 3 days. Controls were exposed to filtered air. Generated fume was collected, and particle size and elemental composition were determined. Bronchoalveolar lavage was done on days 0, 8, 21, and 42 after the last exposure to assess lung injury/inflammation and to recover lung phagocytes. Non-lavaged lung samples were analyzed for total and specific metal content as a measure of metal persistence. Both welding fumes were similar in particle morphology and size. Following was the chemical composition of the fumes-stainless steel: 57% Fe, 20% Cr, 14% Mn, and 9% Ni; mild steel: 83% Fe and 15% Mn. There was no effect of the mild steel fume on lung injury/inflammation at any time point compared to air control. Lung injury and inflammation were significantly elevated at 8 and 21 days after exposure to the stainless steel fume compared to control. Stainless steel fume exposure was associated with greater recovery of welding fume-laden macrophages from the lungs at all time points compared with the mild steel fume. A higher concentration of total metal was observed in the lungs of the stainless steel welding fume at all time points compared with the mild steel fume. The specific metals present in the two fumes were cleared from the lungs at different rates. The potentially more toxic metals (e.g., Mn, Cr) present in the stainless steel fume were cleared from the lungs more quickly than Fe, likely increasing their translocation from the respiratory system to other organs.
Debate exists as to whether welding fume is carcinogenic, but epidemiological evidence suggests that welders are an at-risk population for development of lung cancer. Our objective was to expose, by inhalation, lung tumor susceptible (A/J) and resistant C57BL/6J (B6) mice to stainless steel (SS) welding fume containing carcinogenic metals and characterize the lung-inflammatory and tumorigenic response. Male mice were exposed to air or gas metal arc (GMA)-SS welding fume at 40 mg/m(3)×3 h/day for 6 and 10 days. At 1, 4, 7, 10, 14, and 28 days after 10 days of exposure, bronchoalveolar lavage (BAL) was done. Lung cytotoxicity, permeability, inflammatory cytokines, and cell differentials were analyzed. For the lung tumor study, gross tumor counts and histopathological changes were assessed in A/J mice at 78 weeks after 6 and 10 days of exposure. Inhalation of GMA-SS fume caused an early, sustained macrophage and lymphocyte response followed by a gradual neutrophil influx and the magnitudes of these differed between the mouse strains. Monocyte chemotactic protein-1 (MCP-1), macrophage inflammatory protein-2 (MIP-2), and tumor necrosis factor-α (TNF-α) were increased in both strains while the B6 also had increased interleukin-6 (IL-6) protein. BAL measures of cytotoxicity and damage were similar between the strains and significantly increased at all time points. Histopathology and tumorigenesis were unremarkable at 78 weeks. In conclusion, GMA-SS welding fume induced a significant and sustained inflammatory response in both mouse strains with no recovery by 28 days. Under our exposure conditions, GMA-SS exposure resulted in no significant tumor development in A/J mice.
The goal was to determine if increasing welding voltage changes the physico-chemical properties of the fume and influences lung responses. Rats inhaled 40 mg/m³ (3 h/day × 3 days) of stainless steel (SS) welding fume generated at a standard voltage setting of 25 V (regular SS) or at a higher voltage (high voltage SS) of 30 V. Particle morphology, size and composition were characterized. Bronchoalveolar lavage was performed at different times after exposures to assess lung injury. Fumes collected from either of the welding conditions appeared as chain-like agglomerates of nanometer-sized primary particles. High voltage SS welding produced a greater number of ultrafine-sized particles. Fume generated by high voltage SS welding was higher in manganese. Pulmonary toxicity was more substantial and persisted longer after exposure to the regular SS fume. In summary, a modest raise in welding voltage affected fume size and elemental composition and altered the temporal lung toxicity profile.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.