Superhydrophobicity is generally considered to be a thermodynamically stable wetting state. The stability of the plastron (the thin air film separating the substrate from the water in the superhydrophobic state) was studied in underwater experiments. The plastron exhibited a rapid decay after a well defined onset time, which was found to be dependent on the immersion depth. The plastron decay is explained in terms of a model, which is based on confocal microscopy measurements. The limited underwater plastron stability explains the rarity of permanently submerged superhydrophobic surfaces in nature and limits their scope for commercial applications.
This paper describes the electroactuation of microcantilevers coated on one side with cationic polyelectrolyte brushes. We observed very strong cantilever deflection by alternating the potential on the cantilever between +0.5 and -0.5 V at frequencies up to 0.25 Hz. The actuation resulted from significant increases in the expansive stresses in the polymer brush layer at both negative and positive potentials. However, the deflection at negative bias was significantly larger. We have developed a theoretical framework that correlates conformational changes of the polymer chains in the brush layer with the reorganization of ions due to the potential bias. The model predicts a strong increase in the polymer volume fraction, close to the interface, which results in large expansive stresses that bend the cantilever at negative potentials. The model also predicts that the actuation responds much stronger to negative potentials than positive potentials, as observed in the experiments.
The behaviour of miscible blends of polystyrene (PS)/poly(vinyl methyl ether)(PVME) of varying compositions has been investigated at temperatures where PS and PVME are miscible. The PVME is seen to enrich the polymer-air surface, forming a layer with a width that is comparable to the correlation length. Further heating close to the demixing temperature results in the formation of a capillary instabilities at the polymer surface exhibiting a spinodal-like pattern with a characteristic wavelength that depends on the blend composition. Formation of these instabilities is seen for all blend compositions. We propose that these wetting induced instabilities result from coupled height and composition fluctuations in the PVME enriched surface layer, driving the build-up of long wavelength fluctuations.
The petal epidermis acts not only as a barrier to the outside world but also as a point of interaction between the flower and potential pollinators. The presence of conical petal epidermal cells has previously been shown to influence the attractiveness of the flower to pollinating insects. Using Antirrhinum isogenic lines differing only in the presence of a single epidermal structure, conical cells, we were able to investigate how the structure of the epidermis influences petal wettability by measuring the surface contact angle of water drops. Conical cells have a significant impact on how water is retained on the flower surface, which may have indirect consequences for pollinator behaviour. We discuss how the petal epidermis is a highly multifunctional one and how a battery of methods, including the use of isogenic lines, is required to untangle the impacts of specific epidermal properties in an ecological context.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.