No abstract

No abstract

No abstract

Most copper flotation tailings contain a significant amount of sulfide minerals that can generate effluent resulting from the oxidation of sulfides when they are exposed to oxygen and water. This study aimed to characterize and evaluate the acid drainage potential of five different copper flotation tailings, named samples I, II, III, IV, and V. Sample I was taken from an industrial operation, while Samples II, III, IV, and V were produced in pilot plant tests. All samples were characterized and submitted to static acid drainage tests, such as paste pH, Net Acid Generation (NAG) pH, and Modified Acid-Base Accounting (MABA). The sulfur as sulfide/total sulfur mass ratios varies from 0.40 up to 0.89 showing the presence of a high amount of minerals rich in pyrite and alunite, being higher than 13 wt% of pyrite in samples IV and V and around 19 wt% of alunite in sample III. Samples I and II presented a high number of alkaline elements, totalizing more than 8 wt% of K 2 O+CaO+MgO, while samples III, IV, and V show the lowest amount of these elements (<4 wt%). Only samples III, IV, and V show Paste pH results lower than 5.0, indicating superficial oxidation on their surfaces and/or the presence of water-soluble acidity minerals. Due to the high pyrite content in samples III and IV, it was not possible to measure their NAG pH due to the high heat released with the addition of hydrogen peroxide. The low NAG pH obtained with sample III (5.30) was due to its high pyrite content (0.30 wt%) in comparison with the results obtained with sample I (NAG pH of 8.15 and 0.10 wt% of pyrite), and sample II (NAG pH of 8.18 and 0.10 wt% of pyrite). The MABA results show that samples III, IV and V presented acid drainage potential due to the neutralization potential (NP)/acidity potential (AP) ratio being lower than 1. On the other hand, samples I and II presented NP/AP ratio higher than 4, not showing potential to generate acid drainage. Due to these results, it is recommended to carry out acid drainage kinetic tests with samples III, IV, and V to determine the long-term weathering rates, evaluate lag time to acid generation and provide reaction rates for geochemical modeling.

Potassium chloride (KCl) accounts for most of the potassium (K) used in world agriculture and represents 96% of the world potash capacity. The other 4% includes potassium sulfate (K 2 SO 4), potassium nitrate (KNO 3) and potassium-magnesium based salts. In this sense, the prediction of the solubility of electrolytes in aqueous solutions is important to provide data for processes that extract potassium salts from multicomponent brines. In this work, Pitzer´s and Harvie´s models were used to calculate the amount and composition of crystallized salts after water evaporation. The process involved four crystallization steps starting from multicomponent brines represented by the quinary Na-K-Ca-Mg-Cl aqueous system at 20°C. The temperature of 20°C was chosen because it is the average process brine temperature in many dry salt lakes. The Pitzer´s and Harvie´s models allowed performing a material balance in solar ponds producing saleable salts like sodium, potassium, magnesium and calcium chlorides.