To facilitate the
ongoing transition toward a circular economy,
the availability of renewable materials for additive manufacturing
becomes increasingly important. Here, we report the successful fabrication
of complex shaped prototypes from biobased acrylate photopolymer resins,
employing a commercial stereolithography apparatus (SLA) 3D printer.
Four distinct resins with a biobased content ranging from 34 to 67%
have been developed. All formulations demonstrated adequate viscosity
and were readily polymerizable by the UV-laser-based SLA process.
Increasing the double-bond concentration within the resin results
in stiff and thermally resilient 3D printed products. High-viscosity
resins lead to high-resolution prototypes with a complex microarchitecture
and excellent surface finishing, comparable to commercial nonrenewable
resins. These advances can facilitate the wide application of biobased
resins for construction of new sustainable products via stereolithographic
3D printing methods.
Take-down policy If you believe that this document breaches copyright please contact us providing details, and we will remove access to the work immediately and investigate your claim.
The zeta-potential of monodisperse polystyrene latices as a function of ionic strength is reported. Latices
exhibit anomalous electrokinetic behavior: instead of the expected decrease in mobility with increasing
electrolyte concentration, a maximum occurs. In this paper it is shown that both in electrophoresis of
dilute dispersions and in electroomosis of concentrated plugs, the zeta-potential as a function of ionic
strength passes through approximately the same maximum at about the same electrolyte concentration.
After the correction for the influence of conductance by ions in the diffuse electrical double layer, using
O'Briens model, still a slight maximum exists. The results provided an estimate of the Stern layer thickness.
An analysis using the hairy layer model, when surface conductance was neglected, provided an estimate
of the hairy layer thickness.
Oil‐spill remediation is an international environmental challenge, and superamphiphilic membranes, as a promising solution, have recently drawn lots of attention. However, the robustness of the conventional membrane design is less satisfying under severe conditions during practical applications. Additionally, it is unavoidable for the membranes to face a series of foulants in their practical working environment, for example, algae and sand. These foulants will block the membrane, which leads to a new economic and environmental problem in terms of waste management at the end of their life. To address the aforementioned challenges, a new generation of superamphiphilic vitrimer epoxy resin membranes (SAVER) to separate oil and water efficiently is reported. Similar to classical epoxy resins, SAVER shows strong mechanical robustness and sustains exposure to aqua regia and sodium hydroxide solutions. Furthermore, the blocked membrane can be easily recovered when contaminated with mixed foulants by using dynamic transesterification reactions in the polymer network. The ease with which biobased SAVER can be manufactured, used, recycled, and re‐used without losing value points to new directions in designing a closed‐loop superamphiphilic membrane life cycle.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.