The main issues associated with the development of two-phase mechanically pumped loops (2-MPL) for thermal control systems of spacecraft with large heat dissipation were formulated back in the early 80s. They have undeniable advantages over single-phase loops with mechanical pumping and two-phase capillary pumped loops at power more than 6 kW and heat transfer distance more than 10 meters. Intensive research and development of such systems started in the USA together with European, Canadian and Japanese specialists due to plans to build new high-power spacecraft and the Space Station Freedom project. In the 90's, S. P. Korolev Rocket and Space Corporation Energia (Russia) was developing a 2-MPL for the Russian segment of the International Space Station with the capacity of 20...30 kW. For this purpose, leading research organizations of the former Soviet Union were involved. In the last two decades, interest in two-phase heat transfer loops has significantly increased because of high-power stationary communications satellites and autonomous spacecraft for Lunar and Martian missions. The paper presents a retrospective review of worldwide developments of 2-MPLs for thermal control systems of spacecraft with large heat dissipation from the early 80's to the present. The participation of scientists and engineers of the Ukrainian National Aerospace University "KhAI" and the Center of Technical Physics is considered. The main directions of research, development results, and scientific and technical problems on the way to the practical implementation of such system are considered. Despite a large amount of research and development work done, there were no practically implemented projects of spacecraft with the high-power thermal control system until recent days. The first powerful stationary satellite with the 2-MPL was SES-17 satellite on the NEOSAT platform by Thales Alenia Space - France. The satellite was successfully launched into space on October 24, 2021 by onboard Ariane 5 launcher operated by Arianespace from the Europe’s Spaceport in Kourou, French Guiana.

No abstract

The paper proposes a model of heat transfer in the evaporator of the spacecraft thermal control system. The model allows to calculate the average temperature of the evaporator wall and to build a "boiling curve" in a wide range of thermal loads. Adequacy of the model is confirmed by experimental studies on an aluminum thermal sink with high longitudinal thermal conductivity in the range of parameters typical for the thermal control systems of spacecrafts. Ammonia is used as a working fluid. The model might be recommended for use in zero gravity and normal ground conditions.