A major challenge when designing cell scaffolds for chondrocyte delivery in vivo is creating scaffolds with sufficient mechanical properties to restore initial function while simultaneously controlling temporal changes in the gel structure to facilitate tissue formation. To address this design challenge, degradable photocrosslinked hydrogels based on poly(ethylene glycol) were investigated. To alter the gel's initial mechanical properties, hydrogels were fabricated by varying the initial macromer concentration from 10% to 15% to 20%. A twofold increase in macromer concentration resulted in an eightfold increase in the initial compressive modulus from 60 to 500 kPa. Gel degradation was tailored by incorporating fast-degrading crosslinks that enable maximal extracellular matrix (ECM) diffusion with time and a minimal number of nondegrading (or slowly degrading) crosslinks to maintain scaffold integrity and prevent complete gel erosion during tissue formation. Chondrocytes encapsulated in these gels produced cartilaginous tissue rich in glycosaminoglycans and collagen as seen biochemically and histologically. Interestingly, mass loss appeared to more closely match tissue secretion in gels fabricated from a 15% macromer concentration. However, the spatial ECM distribution was grossly similar in all three gels. By tailoring gel degradation and controlling network evolution during degradation, gels with optimal properties can be fabricated to support initially physiologic compressive loads while simultaneously supporting the formation of a neotissue.

No abstract

Subthalamic nucleus (STN) deep brain stimulation (DBS) has become an accepted treatment for the motor manifestations of Parkinson disease (PD). The beneficial motor effects of STN DBS are likely due to modulation of BG output to frontal cortical regions associated with motor control, but the underlying neurophysiology of STN DBS effects, especially at the level of the cortex, is not well understood. In this study, we examined the effects of STN DBS on motor disability and visual working memory, a cognitive process supported by pFC. We tested 10 PD participants off medications, ON and OFF stimulation, along with 20 normal controls on a visual working memory task while simultaneously recording cortical EEG. In the OFF state, PD patients had poor motor function, were slower and less accurate in performing the working memory task, and had greater amplitudes and shorter latencies of the N200 ERP response. DBS improved clinical motor function, reduced N200 amplitudes, and increased N200 latencies but had little effect on working memory performance. We conclude that STN DBS normalizes neurophysiological activity in fronto striatal circuits and this may independently affect motor and cognitive function.

Introduction: Resurfacing complex full thickness wounds requires free tissue transfer which creates donor site morbidity. We describe a method to fabricate a skin flap equivalent with a hierarchical microvascular network. Materials & methods: We fabricated a flap of skin-like tissue containing a hierarchical vascular network by sacrificing Pluronic® F127 macrofibers and interwoven microfibers within collagen encapsulating human pericytes and fibroblasts. Channels were seeded with smooth muscle and endothelial cells. Constructs were topically seeded with keratinocytes. Results: After 28 days in culture, multiphoton microscopy revealed a hierarchical interconnected network of macro- and micro-vessels; larger vessels (>100 μm) were lined with a monolayer endothelial neointima and a subendothelial smooth muscle neomedia. Neoangiogenic sprouts formed in the collagen protodermis and pericytes self-assembled around both fabricated vessels and neoangiogenic sprouts. Conclusion: We fabricated a prevascularized scaffold containing a hierarchical 3D network of interconnected macro- and microchannels within a collagen protodermis subjacent to an overlying protoepidermis with the potential for recipient microvascular anastomosis.

OBJECTIVES/GOALS: To determine if decellularized costal cartilage (DCC), which could theoretically be obtained “off the shelf,” would provide similar results to autologous cartilage grafts previously studied in this lab, thereby widening the application of our novel nipple engineering approach to all patients undergoing nipple reconstruction. METHODS/STUDY POPULATION: PLA scaffolds (diameter: 1.0 cm, height: 1.0 cm) were printed using a PRUSA 3D printer and sterilized. Lamb costal cartilage was minced (1 mm3) or zested (<0.2 mm3) and then decellularized. The quality of decellularization was assessed using DNA quantification and histological analysis. DCC was then packed into PLA scaffolds and implanted subcutaneously into immunocompetent Sprague Dawley rats using a CV flap technique. The constructs were explanted and evaluated up to 6 months after implantation. RESULTS/ANTICIPATED RESULTS: All nipple reconstructions showed well-preserved diameter and projection due to persistence of the external scaffolds at 1, 3, and 6 months. Mass and volume of engineered tissue was well-preserved over all timepoints. Compared to implantation values, engineered zested nipples demonstrated a 12% mass increase and a 22% volume increase at 6 months. Minced nipples illustrated a similar mass and volume gain with a 21% increase in mass and a 13% increase in volume at 6 months secondary to infiltration of fibrovascular tissue and growth through scaffold wall pores, respectively. Histologic analysis demonstrated a mild inflammatory infiltrate 1 month after implantation which was replaced by fibrovascular tissue by 3 months that remained stable through 6 months. The processed DCC structure remained unchanged over time. DISCUSSION/SIGNIFICANCE: Using acellular ovine xenograft within bioabsorbable scaffolds, we have engineered neonipples that maintain their volume for at least 6 months. DCC architecture is well-preserved with minimal evidence of immune-mediated degradation. By using DCC, this novel approach to nipple engineering may be applied to any patient requiring reconstruction.