A general method for the formation of a broad family of silicon nanotube arrays (Si NTAs) relevant to diverse fields--ranging from energy storage to therapeutic platforms--is described. Such nanotubes demonstrate a thickness-dependent dissolution behavior important to its potential use in drug delivery. Under selected conditions, novel porous silicon nanotubes can be prepared when the shell thickness is on the order of 12 nm or less, capable of being loaded with small molecules such as luminescent ruthenium dyes associated with dye-sensitized photovoltaic devices.

Sample autofluorescence (fluorescence of inherent components of tissue and fixative-induced fluorescence) is a significant problem in direct imaging of molecular processes in biological samples. A large variety of naturally occurring fluorescent components in tissue results in broad emission that overlaps the emission of typical fluorescent dyes used for tissue labeling. In addition, autofluorescence is characterized by complex fluorescence intensity decay composed of multiple components whose lifetimes range from sub-nanoseconds to a few nanoseconds. For these reasons, the real fluorescence signal of the probe is difficult to separate from the unwanted autofluorescence. Here we present a method for reducing the autofluorescence problem by utilizing an azadioxatriangulenium (ADOTA) dye with a fluorescence lifetime of approximately 15 ns, much longer than those of most of the components of autofluorescence. A probe with such a long lifetime enables us to use time-gated intensity imaging to separate the signal of the targeting dye from the autofluorescence. We have shown experimentally that by discarding photons detected within the first 20 ns of the excitation pulse, the signal-to-background ratio is improved fivefold. This time-gating eliminates over 96 % of autofluorescence. Analysis using a variable time-gate may enable quantitative determination of the bound probe without the contributions from the background.

Time-resolved and temperature-dependent photoluminescence (PL) spectroscopy of ternary compound copper indium disulfide (CuInS2, or CIS) core materials, CIS/ZnS coreshells, and quaternary compound ZnCuInS2 (ZnCIS) revealed their optical properties with spectral, temporal, and thermal characteristics, which were closely linked to surface-related recombination, and shallow or deep defect-related donor-acceptor transitions. The PL peaks of semiconductor nanocrystals (SNCs) with sizes near Bohr radius displayed at ∼775 nm for CIS, ∼605 nm for CIS/ZnS, and ∼611 nm for ZnCIS. The spectral blue shift and spectral narrowing with CIS/ZnS and ZnCIS are assigned to the increased spatial confinement and surface regularity with the etching of core materials. Both the shorter lifetime at surface-trapped states or interface states and the longer lifetime at intrinsic defect-related states of CIS, CIS/ZnS, and ZnCIS SNCs were widely distributed across the entire PL spectral region. The surface or interface-trapped electrons were thermally active even at low temperatures, but the electrons at intrinsic defect-related states were relatively stable, which was attributable to the strong Coulomb energy between the charge carriers.

BSA protected gold nanoclusters (Au25) are attracting great deal of attention due to their unique spectroscopic properties and possible use in biophysical applications. Although there are reports on synthetic strategies, spectroscopy and applications, little is known about their polarization behavior. In this study, we synthesized the BSA protected Au25 nanoclusters and studied their steady state and time resolved fluorescence properties including polarization behavior in different solvents: glycerol, propylene glycol and water. We demonstrated that the nanocluster absorption can be separated from the extinction spectrum by subtraction of Rayleigh scattering. The nanocluster absorption spectrum is well approximated by three Gaussian components. By a comparison of the emissions from BSA Au25 clusters and rhodamine B in water, we estimated the quantum yield of nanoclusters to be higher than 0.06. The fluorescence lifetime of the BSA Au25 cluster is long and heterogeneous with an average value of 1.84 μs. In glycerol at −20°C the anisotropy is high, reaching a value of 0.35. However, the excitation anisotropy strongly depends on the excitation wavelengths indicating a significant overlap of the different transition moments. The anisotropy decay in water reveals a correlation time below 0.2 μs. In propylene glycol the measured correlation time is longer and initial anisotropy depends on the excitation wavelength. The BSA Au25 cluster, due to long lifetime and high polarization, can potentially be used in studying large macromolecules such as protein complexes with large molecular weight.

Ternary AgInS2 quantum dots (QDs) have been found as promising cadmium-free, red-shifted, and tunable luminescent bio-probes with efficient Stokes and anti-Stokes excitations and luminescence lifetimes (ca. 100 ns) convenient for time resolved techniques like fluorescence life-time imaging. Although the spectral properties of the AgInS2 QDs are encouraging, the complex recombination kinetics in the QDs being still far from understood, limits their full utility. In this paper we report on a model describing the recombination pathways responsible for large deviations from the first-order decay law observed commonly in the ternary chalcogenides. The presented results were evaluated by means of individual AgInS2 QD spectroscopy aided by first principles calculations including the electronic structure and structural reconstruction of the QDs. Special attention was devoted to study the impact of the surface charge state on the excited state relaxation and effect of its passivation by Zn(2+) ion alloying. Two different blinking mechanisms related to defect-assisted charge imbalance in the QD responsible for fast non-radiative relaxation of the excited states as well as surface recharging of the QD were found as the major causes of deviations from the first-order decay law. Careful optimization of the AgInS2 QDs would help to fabricate new red-shifted and tunable fluorescent bio-probes characterized by low-toxicity, high quantum yield, long luminescence lifetime, and time stability, leading to many novel in vitro and in vivo applications based on fluorescence lifetime imaging (FLIM) and time-gated detection.