No abstract

For a single-phase Shunt Active Power Filter (SAPF) with a two-step prediction, this research presents a modified current control based on a Model Predictive Current Control (MPCC) technique. An H-bridge inverter, a DC link capacitor, and a filter inductor comprise the single-phase SAPF topology. The SAPF reference current is computed using the DC-link capacitor voltage regulation-based PI control technique. The weighting factor-based model predictive current controller is used to track the current commands. The essential dynamic index for evaluating waveform quality is the Total Harmonic Distortion (THD) of a source current and switching frequency of power switches. The conventional methods the THD and switching frequency are not considered as an objective function, so that a weighting factor-based MPCC technique is used to obtain a good compromise between the THD of the source current and switching frequency of power switches. Through MATLAB simulation and experimentation with the Cyclone-IV EP4CE30F484 FPGA board, the usefulness of the proposed control technique is proven. As compared with hysteresis, predictive PWM, and conventional MPCC control methods, the cost function-based MPCC algorithm provides a lower switching frequency (13.4 kHz) with an optimal source current THD value.

No abstract

No abstract

Background: In recent days grid-tied PV power systems play a vital role in the entire energy system. In a grid –tied PV system Transformerless Inverter (TI) topologies are preferred for its reduced price, improved efficiency, lightweight etc. Therefore many transformerless topologies have been proposed and verified with real power injection only. Recently, almost every international standard has imposed that a specified amount of reactive power should be handled by the grid-tied PV inverter. According to the standard VDE-AR-N4105, grid-tied PV inverter of power rating below 3.68kVA, should attain Power Factor (PF) from 0.95 leading to 0.95 lagging. Objective: To address this issue of grid-tied PV system with reactive power control, in this paper Fuzzy gain scheduling controller is proposed as a power controller for High Efficiency Transformeless (HETL) inverter. The performance of the proposed scheme is analyzed and validated with the comparison of a conventional PI controller based active and reactive power controllers. Methods: This paper is with the intention of improvement in the performance of the system, the FGS controller is anticipated as active and reactive power controllers. In conventional PI controller gains are constant for any value of the error, which makes error and delay in optimum value of voltage (Vα and Vß). Hence in this analysis FGS controller tunes PI controller gain with respect to change in active and reactive power error. Results: Comparative performance of PI and FGS based HETL inverter is presented in this paper. It is noted that for any cases either Pref is constant or variable the FGS reduces ripple than PI based HETL inverter system. Compare to constant reference power case variable reference case produces more ripples in both systems. Conclusion: From the analysis FGS based HETL inverter in a grid-tied PV based power system produces the best performance in all aspects such as voltage, active power and reactive power.