The next step in the Wendelstein stellarator line is the large superconducting device Wendelstein 7-X, currently under construction in Greifswald, Germany. Steady-state operation is an intrinsic feature of stellarators, and one key element of the Wendelstein 7-X mission is to demonstrate steady-state operation under plasma conditions relevant for a fusion power plant. Steady-state operation of a fusion device, on the one hand, requires the implementation of special technologies, giving rise to technical challenges during the design, fabrication and assembly of such a device. On the other hand, also the physics development of steady-state operation at high plasma performance poses a challenge and careful preparation. The electron cyclotron resonance heating system, diagnostics, experiment control and data acquisition are prepared for plasma operation lasting 30 min. This requires many new technological approaches for plasma heating and diagnostics as well as new concepts for experiment control and data acquisition.

This article describes a neutral particle analyzer/isotope separator (ISEP) developed for measurement of the relative hydrogen isotope composition of Joint European Torus (JET) plasmas. The ISEP deployed on the JET can be regarded as a prototype of an instrument proposed for measurement of the spatial profile of the ratio of the density of deuterium and tritium ions in the plasma, nD(r)/nT(r), in the International Thermonuclear Experimental Reactor (ITER). The ISEP makes simultaneous measurements of the energy distribution of efflux of hydrogen isotope atoms (H, D, and T) from the plasma. From such measurements it is possible to deduce the radial profile of the relative hydrogen isotope ion composition of the plasma and radial transport of ions of one isotope across the plasma of another isotope species. The main elements of the ISEP are (a) use of a thin carbon foil for reionization of the incident atoms, thereby eliminating gas stripping cells and gas sources of conventional neutral particle analyzers (NPAs), (b) acceleration of secondary ions in order to access the regime of higher detection efficiency of the NPA and to better separate ion pulses from neutron/γ-ray induced pulses in scintillator detectors, (c) E‖B dispersion of the secondary ions in specially designed nonuniform magnetic and electric fields to provide focusing in the detector plane, increased throughput and greater contrast between neighboring isotopes, and (d) counting of energy and mass analyzed secondary ions using detectors consisting of thin [1⩽t (μm)⩽7] CsI(Tl) scintillators deposited directly on miniature thin window photomultiplier tubes mounted in vacuum. The ISEP has high contrast between atoms of neighboring masses (⩾103 for E≈5 keV and much greater at higher energies), and high detection efficiency (0.06⩽ε⩽0.83 for atoms of 5⩽ (keV)⩽150. ISEP detectors have very low sensitivity to neutrons and γ rays (⩽10−7 of ion sensitivity), making it feasible to use the ISEP in JET DT experiments without any shielding. Only a modest amount of neutron/γ-ray shielding would be required in the ITER for similar applications of the ISEP. The initial experiments on JET plasmas using the ISEP demonstrate well the capabilities of the instrument for measurement of the hydrogen isotope composition of the plasma and the energy distribution function of isotope ions.

No abstract

Transitions to improved core electron heat confinement are triggered by low order rational magnetic surfaces in TJ-II ECH plasmas. Experiments are performed changing the magnetic shear around the rational surface n/m=3/2 to study the influence of the island width on the transition, and ECH power modulation is used to look at transport properties. The improvement in the electron heat confinement shows no obvious dependence on the magnetic shear. Transitions triggered by the rational surface n/m=4/2 show an increase in the ion temperature synchronized with the increase in the electron temperature. Ion temperature changes had not been previously observed either in TJ-II or in any other helical device.

This paper presents an overview of experimental results and progress made in investigating the link between magnetic topology, electric fields and transport in the TJ-II stellarator. The smooth change from positive to negative electric field observed in the core region as the density is raised is correlated with global and local transport data. A statistical description of transport is emerging as a new way to describe the coupling between profiles, plasma flows and turbulence. TJ-II experiments show that the location of rational surfaces inside the plasma can, in some circumstances, provide a trigger for the development of core transitions, providing a critical test for the various models that have been proposed to explain the appearance of transport barriers in relation to magnetic topology. In the plasma core, perpendicular rotation is strongly coupled to plasma density, showing a reversal consistent with neoclassical expectations. In contrast, spontaneous sheared flows in the plasma edge appear to be coupled strongly to plasma turbulence, consistent with the expectation for turbulent driven flows. The local injection of hydrocarbons through a mobile limiter and the erosion produced by plasmas with well-known edge parameters opens the possibility of performing carbon transport studies, relevant for understanding co-deposit formation in fusion devices.