Carbon-containing NiCo2S4 hollow-nanoflake structures were fabricated by a one-step solvothermal method using CS2 as a single source for sulfidation and carbonization. The reaction mechanism for the hollow structure with carbon residues was explored based on the formation of a bis(dithiocarbamate)-metal complex and the Kirkendall effect during solvothermal synthesis. The NiCo2S4 nanoflake electrode exhibited a high specific capacitance of 1722 F g-1 (specific capacity 688.8 C g-1) at a current density of 1 A g-1 and an excellent cycling stability (capacity retention of 98.8% after 10 000 cycles). The as-fabricated asymmetric supercapacitor based on NiCo2S4 nanoflakes and activated carbon electrodes revealed a high energy density of 38.3 W h kg-1 and a high power density of 8.0 kW kg-1 with a capacitance retention of 91.5% and a coulombic efficiency of 95.6% after 5000 cycles, highlighting its great potential for practical supercapacitor applications.

A successive preparation of FeCo2O4 nanoflakes arrays on nickel foam substrates is achieved by a simple hydrothermal synthesis method. After 170 cycles, a high capacity of 905 mAh g(-1) at 200 mA g(-1) current density and very good rate capabilities are obtained for lithium-ion battery because of the 2D porous structures of the nanoflakes arrays. The distinctive structural features provide the battery with excellent electrochemical performance. The symmetric supercapacitor on nonaqueous electrolyte demonstrates high specific capacitance of 433 F g(-1) at 0.1 A g(-1) and 16.7 F g(-1) at high scan rate of 5 V s(-1) and excellent cyclic performance of 2500 cycles of charge-discharge cycling at 2 A g(-1) current density, revealing excellent long-term cyclability of the electrode even under rapid charge-discharge conditions.

The development of Li-O2 battery electrocatalysts has been extensively explored recently. The Co3O4 oxide has attracted much attention because of its bifunctional activity and high abundance. In the present study, toxic Co(2+) has been replaced through the substitution on the tetrahedral spinel A site ions with environmental friendly metals (Mn(2+), Fe(2+), Ni(2+), and Zn(2+)), and porous nanorod structure are formed. Among these spinel MCo2O4 cathodes, the FeCo2O4 surface has the highest Co(3+) ratio. Thus, oxygen can be easily adsorbed onto the active sites. In addition, Fe(2+) in the tetrahedral site can easily release electrons to reduce oxygen and oxidize to half electron filled Fe(3+). The FeCo2O4 cathode exhibits the highest discharging plateau and lowest charging plateau as shown by the charge-discharge profile. Moreover, the porous FeCo2O4 nanorods can also facilitate achieving high capacity and good cycling performance, which are beneficial for O2 diffusion channels and Li2O2 formation/decomposition pathways.