Objective In dental restorations, color determination is very important for achieving esthetic results. The aim of this study was to compare visual shade selection using digital methods and to assess the repeatability of the utilized intraoral scanners. Materials and methods In 31 probands, tooth color was determined on teeth 11, 13, and 16. Shade selection was performed visually by a dentist and digitally using Trios 3 and Cerec Omnicam. Three measurements were performed to determine the repeatability of intraoral scanners. Fleiss' κ was used for statistical evaluation of the repeatability and Cohen's κ was used for comparison of methods. Results The visual method showed only slight agreement with Trios 3 (Cohen's κ : 0.198) and Cerec Omnicam (Cohen's κ : 0.115). Moderate agreement was found between Trios 3 and Cerec Omnicam (Cohen's κ : 0.452). In terms of repeatability, Trios 3 scored higher overall than Cerec Omnicam (Fleiss' κ : 0.612 vs. 0.474). Conclusion Intraoral scanners can facilitate the workflow in clinical practice. They are a good supplement for color determination, but should additionally be confirmed by the visual method. Clinical significance: The use of digital instruments is increasingly being preferred over conventional treatments. Therefore, it is essential to continuously improve the accuracy of intraoral scanners for color selection in order to offer an alternative to visual methods.

The aim of this study was to compare the trueness of complete- and partial-arch impressions obtained using conventional impression materials and intraoral scanners in vivo. Full-arch impressions were taken using polyether and polyvinylsiloxane. Gypsum casts were digitized using a laboratory scanner (IM, AF). Casts obtained from polyether impressions were also scanned using an industrial blue light scanner to construct 3D reference models. Intraoral scanning was performed using CEREC Omnicam (CO) and Trios 3 (TR). Surface matching software (Atos Professional) enabled to determine the mean deviations (mean distances) from the reference casts. Statistically significant discrepancies were calculated using the Wilcoxon signed-rank test. The mean distance for trueness ranged from 0.005 mm (TR) to 0.023 mm (IM) for the full arch, from 0.001 mm (CO) to 0.068 mm (IM) for the anterior segment, and from 0.019 mm (AF) to 0.042 mm (IM) for the posterior segment. Comparing the anterior vs. the posterior segment, significantly less deviations were observed for anterior with CO (p < 0.001) and TR (p < 0.001). Full-arch comparisons revealed significant differences between AF vs. IM (p = 0.014), IM vs. CO (p = 0.002), and IM vs. TR (p = 0.001). Full-arch trueness was comparable when using Affinis and the two intraoral scanners CEREC Omnicam and Trios 3. The digital impression devices yielded higher local deviations within the complete arch. Digital impressions of the complete arch are a suitable and reliable alternative to conventional impressions. However, they should be used with caution in the posterior region.Trial registration: Registration number at the German Clinical Trial Register (04.02.2022): DRKS00027988 (https://trialsearch.who.int/).