No abstract

Novel chitosan composite coatings containing titania nanoparticles (n-TiO 2 ) for biomedical applications were developed by electrophoretic deposition (EPD) from ethanol-water suspensions. The optimal ethanol-water ratio was studied in order to avoid bubble formation during the EPD process and to ensure homogeneous coatings. Different n-TiO 2 contents (0.5-10 g L 21) were studied for a fixed chitosan concentration (0.5 g L 21) and the properties of the electrophoretic coatings obtained were characterized.Coating composition was analyzed by thermogravimetric analysis (TG), Fourier transform infrared spectroscopy (FTIR) and X-ray diffraction (XRD) analysis. Scanning electron microscopy (SEM) was employed to study both the surface and the cross section morphology of the coatings, and the thicknesses (2-6 mm) of the obtained coatings were correlated with the initial ceramic content. Contact angle measurements, as a preliminary study to predict hypothetic protein attachment on the coatings, were performed for different samples and the influence of a second chitosan layer on top of the coatings was also tested. Finally, the electrochemical behavior of the coatings, evaluated by polarization curves in DMEM at 37 uC, was studied in order to assess the corrosion resistance provided by the n-TiO 2 /chitosan coatings.

No abstract

Where a licence is displayed above, please note the terms and conditions of the licence govern your use of this document. When citing, please reference the published version. Take down policy While the University of Birmingham exercises care and attention in making items available there are rare occasions when an item has been uploaded in error or has been deemed to be commercially or otherwise sensitive.

This article presents the results of an experimental investigation designed to deposit chitosan/hexagonal boron nitride (h-BN) and chitosan/h-BN/titania (TiO2) composites on SS316L substrates using electrophoretic deposition (EPD) for potential antibacterial applications. The influence of EPD parameters (voltage and deposition time) and relative concentrations of chitosan, h-BN and TiO2 in suspension on deposition yield was studied. The composition and structure of deposited coatings were investigated by FTIR, XRD and SEM. It was observed that h-BN and TiO2 particles were dispersed in the chitosan matrix through simultaneous deposition. The adhesion between the electrophoretic coatings and the stainless steel substrates was tested by using tape test technique, and the results showed that the adhesion strength corresponded to 3B and 4B classes. Corrosion resistance was evaluated by electrochemical polarization curves, indicating enhanced corrosion resistance of the chitosan/h-BN/TiO2 and chitosan/h-BN coatings compared to the bare stainless steel substrate. In order to investigate the in-vitro inorganic bioactivity, coatings were immersed in simulated body fluid (SBF) for 28 days. FTIR and XRD results showed no formation of hydroxyapatite on the surface of chitosan/h-BN/TiO2 and chitosan/h-BN coatings, which are therefore non bioactive but potentially useful as antibacterial coatings.