We demonstrate experimentally the guiding and the bending of acoustic waves in highly confined waveguides formed by removing rods from a periodic two-dimensional lattice of steel cylinders immersed in water. Full transmission is observed for a one-period-wide straight waveguide within the full band gap of the perfect phononic crystal. However, when the waveguide width is doubled, destructive interference causes the transmission to vanish in the center of the passband. Waveguiding over a wide frequency range is obtained for a one-period-wide waveguide with two sharp 90° bends. Finite-difference time-domain computations are found to be in good agreement with the measurements

A complete surface acoustic wave band gap is found experimentally in a two-dimensional square-lattice piezoelectric phononic crystal etched in lithium niobate. Propagation in the phononic crystal is studied by direct generation and detection of surface waves using interdigital transducers. The complete band gap extends from 203 to 226 MHZ, in good agreement with theoretical predictions. Near the upper edge of the complete band gap, it is observed that radiation to the bulk of the substrate dominates. This observation is explained by introducing the concept of the sound line.

International audienceWe investigate theoretically the propagation of acoustic waves in a two-dimensional array of cylindrical pillars on the surface of a semi-infinite substrate. Through the computation of the band structure of the periodic array and of the transmission of waves through a finite length array, we show that the phononic crystal can support a number of surface propagating modes in the nonradiative region of the substrate, or sound cone, as limited by the slowest bulk acoustic wave. The modal shape and the polarization of these guided modes are more complex than those of classical surface waves propagating on a homogeneous surface. Significantly, an in-plane polarized wave and a transverse wave with sagittal polarization appear that are not supported by the free surface. In the band structure, guided modes define band gaps that appear at frequencies markedly lower than those expected from the Bragg interference condition. We identify them as originating from local resonances of the individual cylindrical pillars and show their dependence on the geometrical parameters, in particular with the height of the pillars. The transmission of surface acoustic waves across a finite array of pillars shows the signature of the locally resonant band gaps for surface modes and their dependence on the symmetry of the source and its polarization. Numerical simulations are performed by using the finite element method and considering silicon pillars on a silicon substrate