No abstract

The injection of oxygenated water into anoxic aquifers during managed aquifer recharge (MAR) can cause the mobilization of metal(loid)s. Here, we study the processes controlling MAR-induced molybdenum (Mo) release in dolomitic aquifers. Sequential chemical extractions and energy dispersive X-ray spectroscopy combined with scanning electron microscopy point to an association of Mo with easily soluble sulfurized organic matter present in intercrystalline spaces of dolomites or directly incorporated within dolomite crystals. The easily soluble character was confirmed by a batch experiment that demonstrated the rapid mobilization of Mo, dissolved organic carbon, and sulfur. The type and time of batch solution contact with the sulfurized organic matter impacted the release of Mo, as demonstrated by a 36% increase in Mo concentrations when shaking was intensified. Based on the experimental results, a conceptual model for the release of Mo was formulated, where (i) the injection of oxygenated water causes the oxidation of pyrite in the aquifer matrix, and (ii) the associated release of protons (H + ) induces the dissolution of dolomite as a buffering reaction, which (iii) enhances the accessibility of the injectant to intercrystalline and incorporated sulfurized organic matter within dolomite, causing the release of Mo.

No abstract

Sequential extraction analyses are widely used for the determination of element speciation in sediments and soils. Typical sequential extraction protocols were developed to extract from low-carbonate samples and therefore are not necessarily suitable for high-carbonate samples. In this study, we tested increased reagent to sample ratios to adjust an existing sequential extraction procedure to analyze high-CaCO3 samples with concentrations ranging from 70 to above 90 %. Complete dissolution of the CaCO3 phase, and a higher extraction efficiency of manganese associated with the carbonate phase, was achieved when using four times the original reagent to sample ratio in the 2nd extraction step. This increase of reagent did not compromise the extraction of subsequent phases as shown by unaffected Fe concentrations in a low-carbonate sample. Hence, an essential outcome was that increasing the solution to sample ratio did not lead to the dissolution of other sedimentary phases, such as hydrous and crystalline iron oxides or sulfides. Thus, compared to other extraction protocols that use a lower reagent to sample ratio in the carbonate dissolution step, the new protocol allowed the complete extraction of oxide and sulfide phases in the following extraction steps. Furthermore, the study demonstrated the benefit of replacing Na-acetate with NH4-acetate to extract exchangeable ions and carbonates. We observed increased intensities for several analytes, i.e., trace metals such as Mo and As, due to less suppression of the analyte signal by NH4-acetate than by Na-acetate during analysis by inductively coupled plasma optical emission spectrometry (ICP-OES).

No abstract