Pyrogenic carbon (PyC) constitutes a significant fraction of organic carbon in most soils. However, PyC soil stocks are generally smaller than what is expected from estimates of PyC produced from fire and decomposition losses, implying that other processes cause PyC loss from soils. Surface erosion has been previously suggested as one such process. To address this, following a large wildfire in the Rocky Mountains (CO, USA), we tracked PyC from the litter layer and soil, through eroded, suspended, and dissolved solids to alluvial deposits along riversides. We separated deposited sediment into high‐ and low‐density fractions to identify preferential forms of PyC transport and quantified PyC in all samples and density fractions using benzene polycarboxylic acid markers. A few months after the fire, PyC had yet to move vertically into the mineral soil and remained in the organic layer or had been transported off site by rainfall driven overland flow. During major storm events PyC was associated with suspended sediments in river water and later identified in low‐density riverbank deposits. Flows from an unusually long‐duration and high magnitude rainstorm either removed or buried the riverbank sediments approximately 1 year after their deposition. We conclude that PyC redistributes after wildfire in patterns that are consistent with erosion and deposition of low‐density sediments. A more complete understanding of PyC dynamics requires attention to the interaction of post fire precipitation patterns and geomorphological features that control surface erosion and deposition throughout the watershed.

Because landslide regimes are likely to change in response to climate change in upcoming decades, the need for mechanistic understanding of landslide initiation and up-to-date landslide inventory data is greater than ever. We conducted surficial geologic mapping and compiled a comprehensive landslide inventory of the Denali National Park road corridor to identify geologic and geomorphic controls on landslide initiation in the Alaska Range. The supplemental geologic map refines and improves the resolution of mapping in the study area and adds emphasis on surficial units, distinguishing multiple glacial deposits, hillslope deposits, landslides, and alluvial units that were previously grouped. Results indicate that slope angle, lithology, and thawing ice-rich permafrost exert first-order controls on landslide occurrence. The majority (84%) of inventoried landslides are <0.01 km2 in area and occur most frequently on slopes with a bimodal distribution of slope angles with peaks at 18° and 28°. Of the 85 mapped landslides, a disproportionate number occurred in unconsolidated sediments and in felsic volcanic rocks. Weathering of feldspar within volcanic rocks and subsequent interactions with groundwater produced clay minerals that promote landslide initiation by impeding subsurface conductivity and reducing shear strength. Landslides also preferentially initiated within permafrost, where modeled mean decadal ground temperature is −0.2 ± 0.04 °C on average, and active layer thickness is ~1 m. Landslides that initiated within permafrost occurred on slope angles ~7° lower than landslides on seasonally thawed hillslopes. The bimodal distribution of slope angles indicates that there are two primary drivers of landslide failure within discontinuous permafrost zones: (1) atmospheric events (snowmelt or rainfall) that saturate the subsurface, as is commonly observed in temperate settings, and (2) shallow-angle landslides (<20° slopes) in permafrost demonstrate that permafrost and ice thaw are also important triggering mechanisms in the study region. Melting permafrost reduces substrate shear strength by lowering cohesion and friction along ice boundaries. Increased permafrost deg­radation associated with climate change brings heightened focus to low-angle slopes regionally as well as in high-latitude areas worldwide. Areas normally considered of low landslide potential will be more susceptible to shallow-angle landslides in the future. Our landslide inventory and analyses also suggest that landslides throughout the Alaska Range and similar climatic zones are most likely to occur where low-cohesion unconsolidated material is available or where alteration of volcanic rocks produces sufficient clay content to reduce rock and/or sediment strength. Permafrost thaw is likely to exacerbate slope instability in these materials and expand areas impacted by landslides.