A new kind of the Vernier mechanism that is able to control the size of linear assembly of DNA origami nanostructures is proposed. The mechanism is realized by mechanical design of DNA origami, which consists of a hollow cylinder and a rotatable shaft in it connected through the same scaffold. This nanostructure stacks with each other by the shape complementarity at its top and bottom surfaces of the cylinder, while the number of stacking is limited by twisting angle of the shaft. Experiments have shown that the size distribution of multimeric assembly of the origami depends on the twisting angle of the shaft; the average lengths of the multimer are decamer, hexamer, and tetramer for 0°, 10°, and 20° twist, respectively. In summary, it is possible to affect the number of polymerization by adjusting the precise shape and movability of a molecular structure.

A simple micro-machined pressure sensor, based on the stress-impedance (SI) effect, was fabricated herein using typical micro-fabrication technologies. To sense pressure, a 1-µm thin, soft magnetic metallic film of FeSiB was sputtered and used as a diaphragm. Its electrical response (impedance change) was measured under pressure in a frequency band from 5 to 500 MHz. A lumped-element equivalent electric circuit was used to separate the impedance of the soft magnetic metal from other parasitic elements. The impedance change clearly depended on the applied pressure. It was also shown that the impedance change could be explained by a change in relative permeability, according to the theory of the SI effect. The radial stress in the diaphragm and the relative permeability exhibited a linear relationship. At a measurement frequency of 200 MHz, the largest sensor response, with a gauge factor of 385.7, was found. It was in the same order as the conventional sensors. As the proposed device is very simple, it has the potential for application as a cheap pressure sensor.