Dentigerous cysts are one of the most prevalent types of odontogenic cysts and are associated with the crown of an unerupted tooth, especially of the mandibular third molar. In this study, the characteristics of a dentigerous cyst developed around a mandibular third molar on panoramic radiographs were investigated. The panoramic images of 257 consecutive dentigerous cyst cases associated with a mandibular third molar were analyzed. The mean age of the patients was 45.9 ± 13.3 years. The size of the cyst did not significantly correlate to the age of the patient. The unilocular type (89.1%) and the crown side type (68.5%) were significant. The associated mandibular third molars had a high frequency of class III (64.6%) and position B (48.3%) in Pell and Gregory classification and of horizontal position (36.3%) in angulation. Dentigerous cysts were thought to originate and grow commonly around deeply impacted third molars. The associated third molar with dentigerous cyst tends to have a mesial inclination. Dentigerous cysts do not appear to develop gradually after the crown formation has finished, but arise at various periods randomly.

Volumetric shrinkage (VS) of conventional, bulk-fill, and core build-up resin-based composites (RBCs) of various thickness (1-5 mm) was measured using the modified bonded-disk method with confocal laser scanning microscopy. Additionally, the bottom-totop ratio of Vickers hardness (%VH) was measured. Conventional RBCs exhibited significantly higher VS than bulk-fill and core build-up RBCs (p<0.05). As specimen thickness increased, VS relative to volume (%VS) and difference in VS at each depth (VSdepth) decreased. For conventional RBCs, there was a significant drop in VSdepth between 1 mm and 2 mm (p<0.05), and another drop was observed between 3 mm and 4 mm (p<0.05) where %VH decreased below 90%. For bulk-fill and core build-up RBCs, VSdepth decreased significantly between 2 mm and 3 mm (p<0.05), but %VH exceeded 90% even in 5 mm deep cavities. These results indicated that post-curing contributed to lower shrinkage in deeper layers, and that conventional RBCs were not adequately polymerized at the depth of over 3 mm.