The R3C ligase ribozyme is an artificial ligase ribozyme produced by modification of the ribozyme that lacks cytidine. Here, we attempted to modify the original R3C ribozyme (73 nucleotides) by reducing the number of nucleotides while maintaining the maximum possible catalytic efficiency. By partially deleting both the “grip” (P4 + P5) and “hammer” (P3) stem-loops, we found the critical border to retain activity comparable to that of full-length R3C. The three-way junction structure was necessary to maintain enzymatic function and the stability of the “grip” (P4 + P5) stem had a large influence on the catalytic activity of R3C. The final minimized ribozyme we obtained comprised ~50 nucleotides, comparable to the estimated length of prebiotically synthesized RNA. Our findings suggest that the autocatalytic function in ribozymes is indeed possible to obtain using sequence lengths achievable with prebiotic synthesis.

R3C ligase ribozyme catalyzes the nucleophilic attack by a 3′-hydroxyl on a 5′-α-phosphorus of triphosphates to form a 3′-5′-phosphodiester bond. In the present study, although the truncation of R3C ribozyme was accompanied by a large reduction in ligation activity (decrease by two orders of magnitude compared to that of the ligated product of full-length R3C ribozyme after 18.5 h at 23 °C), the introduction of complementary seven-membered kissing-loops served as a “switch” to reactivate the truncated R3C ribozyme with approximately one-fifth of the activity of the full-length R3C ribozyme. This reactivation occurred in a trans-manner, and the grip region and substrate-binding site of the truncated R3C ribozyme were necessary to locate the substrate in the proper position for ligation with the other molecule. Reactivation resulted from complex tertiary interactions between two ribozymes, including kissing-loop interaction-induced annealing and the formation of a stable duplex. The drastic increase of the activity of poorly active ribozymes through the kissing-loop interaction may provide an important clue into the acquisition of substantial activity during the evolution of the RNA world.

Erythema multiforme is a skin disorder characterised by target epithelial eruption, which is mainly caused by infection or drugs. In this case, we report an erythema multiforme like reaction caused by contact dermatitis against wood, especially santos rosewood. During the hospitalisation, we performed a patch test with lumber used in the patient’s workplace, and recognised a positive response to multiple woods and a simultaneous recurring eruption (flare up) outside of the test site. The findings from this case of contact dermatitis caused by frequently used industrial wood type is important for the management of occupational environments. A review of the literature on erythema multiforme like reaction due to contact dermatitis, including past case reports, has also been provided.