Multiexciton generation (MEG) has been indirectly observed in colloidal quantum dots, both in solution and the solid state, but has not yet been shown to enhance photocurrent in an optoelectronic device. Here, we report a class of solution-processed photoconductive detectors, sensitive in the ultraviolet, visible, and the infrared, in which the internal gain is dramatically enhanced for photon energies Ephoton greater than 2.7 times the quantum-confined bandgap Ebandgap. Three thin-film devices with different quantum-confined bandgaps (set by the size of their constituent lead sulfide nanoparticles) show enhancement determined by the bandgap-normalized photon energy, Ephoton/Ebandgap, which is a clear signature of MEG. The findings point to a valuable role for MEG in enhancing the photocurrent in a solid-state optoelectronic device. We compare the conditions on carrier excitation, recombination, and transport for photoconductive versus photovoltaic devices to benefit from MEG.

Half of the sun's power lies in the infrared. As a result, the optimal bandgaps for solar cells in both the single-junction and even the tandem architectures lie beyond 850 nm. However, progress in low-cost, large-area, physically flexible solar cells has instead been made in organic and polymer materials possessing absorption onsets in the visible. Recent advances have been achieved in solution-cast infrared photovoltaics through the use of colloidal quantum dots. Here we report stable solution-processed photovoltaic devices having 3.6% power conversion efficiency in the infrared. The use of a strongly bound bidentate linker, benzenedithiol, ensures device stability over weeks. The devices reach external quantum efficiencies of 46% in the infrared and 70% across the visible. We investigate in detail the physical mechanisms underlying the operation of this class of device. In contrast with drift-dominated behavior in recent reports of PbS quantum dot photovoltaics, we find that diffusion of electrons and holes over hundreds of nanometers through our PbSe colloidal quantum dot solid is chiefly responsible for the high external quantum efficiencies obtained in this new class of devices.

We synthesize CuGaSe 2 , CuInSe 2 , and Cu(InGa)Se 2 nanoparticles in oleylamine with narrow size distribution using commercial grade copper, indium, gallium salts, and Se powder. Tunable nanoparticle size and composition are achieved through manipulation of reaction temperature and precursor concentrations. Ternary and quaternary materials are engineered by the judicious matching of ligand-precursor reactivities.

Crosslinking molecules have recently been combined with colloidal quantum dots to build robust, closely packed, conductive solid-state devices. Ethanedithiol ͑EDT͒ has been used in PbS quantum dot photovoltaic devices to assist in film formation during fabrication. However, there is evidence that EDT influences the electronic properties of the colloidal quantum dot ͑CQD͒ films. We fabricate thin film field-effect transistors and find that EDT treatment increases the majority carrier mobility by a factor of 10. We attribute this increase to a reduction in interparticle spacing which we observe using transmission electron microscopy. However, this increase is accompanied by a decrease in the majority carrier concentration. Using x-ray photoelectron microscopy, we find that EDT reduces the extent of the surface oxidation which is acting as a p-type dopant in these materials. We find that by lightly reoxidizing, we can redope the CQD films and can do so without sacrificing mobility gains.

Photodetection in semiconductors enables digital imaging, spectroscopy, and optical communications. Integration of solution-processed light-sensing materials with a range of substrates offers access to new spectral regimes, the prospect of enhanced sensitivity, and compatibility with flexible electronics. Photoconductive photodetectors based on solution-cast nanocrystals have shown tremendous progress in recent years; however, high-performance reports to date have employed Pb- and Cd-containing materials. Here we report a high-sensitivity (photon-to-electron gain >40), high-speed (video-frame-rate-compatible) photoconductive photodetector based on In(2)S(3). Only by decreasing the energetic depth of hole traps associated with intrinsic vacancies in beta-phase In(2)S(3) were we able to achieve this needed combination of sensitivity and speed. Our incorporation of Cu(+) cations into beta-In(2)S(3)'s spinel vacancies that led to acceptable temporal response in the devices showcases the practicality of incorporating dopants into nanoparticles. The devices are stable in air and under heating to 215 degrees C, advantages rooted in the reliance on the stable inclusion of dopants into available sites instead of surface oxide species.