We present a comprehensive study of a magnetic sensor system that benefits from a new technique to substantially increase the magnetoelastic coupling of surface acoustic waves (SAW). The device uses shear horizontal acoustic surface waves that are guided by a fused silica layer with an amorphous magnetostrictive FeCoSiB thin film on top. The velocity of these so-called Love waves follows the magnetoelastically-induced changes of the shear modulus according to the magnetic field present. The SAW sensor is operated in a delay line configuration at approximately 150 MHz and translates the magnetic field to a time delay and a related phase shift. The fundamentals of this sensor concept are motivated by magnetic and mechanical simulations. They are experimentally verified using customized low-noise readout electronics. With an extremely low magnetic noise level of ≈100 pT/, a bandwidth of 50 kHz and a dynamic range of 120 dB, this magnetic field sensor system shows outstanding characteristics. A range of additional measures to further increase the sensitivity are investigated with simulations.

We present a resonant micromechanical magnetic field sensor, which utilizes the magnetically induced change in elastic modulus, i.e., the delta-E effect. The sensor is based on magnetoelectric thin film composites, resulting in high sensitivity at room temperature and at low frequencies. The cantilever is electrically excited and read out by a 2 μm AlN piezoelectric layer. Depending on its magnetization, the 2 μm thin film of amorphous (Fe90Co10)78Si12B10 changes its elasticity, which results in a shift of the cantilever's resonance frequency. The sensor is operated in the first or second transversal bending mode at 7.6 kHz or 47.4 kHz. With a limit of detection of 140 pTHz−0.5 at 20 Hz under a magnetic bias field and 1 nTHz−0.5 without external bias field, this sensor exceeds all comparable designs by one order of magnitude.

We present an analytical and experimental study on low-noise piezoelectric thin film resonators that utilize the delta-E effect of a magnetostrictive layer to measure magnetic fields at low frequencies. Calculations from a physical model of the electromechanical resonator enable electrode designs to efficiently operate in the first and second transversal bending modes. As predicted by our calculations, the adapted electrode design improves the sensitivity by a factor of 6 and reduces the dynamic range of the sensor output by 16 dB, which significantly eases the requirements on readout electronics. Magnetic measurements show a bandwidth of 100 Hz at a noise level of about 100 pTHz-0.5