No abstract

The Nankai Trough is a vigorous subduction zone where large earthquakes have been recorded since the seventh century, with a recurrence time of 100 to 200 years. The 1946 Nankaido earthquake was unusual, with a rupture zone estimated from long-period geodetic data that was more than twice as large as that derived from shorter period seismic data. In the center of this earthquake rupture zone, we used densely deployed ocean bottom seismographs to detect a subducted seamount 13 kilometers thick by 50 kilometers wide at a depth of 10 kilometers. We propose that this seamount might work as a barrier inhibiting brittle seismogenic rupture.

[1] At the Japan Trench convergent margin, many large interplate earthquakes of greater than M7.5 frequently occur. Their epicenters have uneven distribution, mostly located in the northern area. To investigate the relationship between this distribution and tectonic structures, we have conducted multichannel seismic surveys since 1996. Our data show two kinds of interplate sedimentary units: a wedge-shaped unit and a channel-like unit. Both units have a lower P wave velocity than the basal part of the overriding island arc crust. The wedge-shaped unit having a velocity of 2-3 km/s is widely distributed over the forearc region in the northern area. Its thickness decreases with depth, becoming several hundred meters at a depth of $12 km. The channel-like unit having a velocity of 3-4 km/s is observed in the southern area, extending in the downdip direction. Its thickness reaches $2 km at a depth of $12 km. If the low velocity of these units results from the existence of fluid, as many authors assume, the units being thick implies higher fluid content assuming constant porosity. Considering that fluid reduces basal friction and with an assumption that fluid available at a specific interface is proportional to the total fluid content in the sediment, the thickness variation of the units would cause different degrees of coupling at the plate boundary along the arc. This may provide one explanation for the regional disparity in the interplate earthquake occurrence in the margin. Furthermore, we attempt to call attention to the possibility that the channel-like sediment works as a shear stress releaser.

No abstract

[1] Differences in the coseismic rupture process between the 1944 Tonankai and the 1946 Nankai earthquakes have been studied by many fault models. To understand what factors control coseismic rupture zones, it is important to investigate differences in deep crustal structures of the rupture zones between the 1944 and 1946 earthquakes. The previously published crustal structure of the rupture zone of the 1946 earthquake shows that the coseismic rupture extends to the Neogene-Quaternary accretionary prism. However, little is known about the structure of the rupture zone of the 1944 earthquake. To obtain a complete image of the seismogenic zone of the 1944 earthquake, a wide-angle seismic survey was performed across the presumed coseismic rupture zone of the 1944 earthquake from ocean to land. Our model for the crustal structure is based on ocean bottom seismographic data. The crustal structure appears characteristic for subducting oceanic crust and a Neogene-Quaternary accretionary prism bounded by an island arc crust. The Neogene-Quaternary accretionary prism reaches a maximum thickness of 7 km at 50 km distance landward from the deformation front. The subducting oceanic crust can be traced down to 35 km. The subduction angle becomes steeper landward, reaching up to 11°beneath the island arc crust. The depth of the top of subducting oceanic crust at the downdip limit of the rupture zone is 23 km, while the updip limit is located beneath the island arc upper crust. Similar structures of the updip and downdip limits are also published for several other subduction zones.