We report on single-photon interference experiments in a Michelson-type interferometer built with two 6-km-long fiber spools, as well as on the active stabilization of the interferometer. A weak coherent light signal was (de-) multiplexed with a strong reference light using wavelength-division multiplexing technique, and real-time feedback control technique was applied for the reference light to actively stabilize the phase fluctuation in the long-armed fiber interferometer. The stabilized interferometer showed phase stability of 0.06 rad, which corresponds to an optical path length fluctuation of 15 nm between the 6-km-long interfering arms. The raw visibility obtained without subtracting noise counts in the single-photon interference experiment was more than 98% for stabilized conditions.

No abstract

The practical realization of long-distance entanglement-based quantum communication systems strongly rely on the observation of highly stable quantum interference between correlated single photons. This task must accompany active stabilization of the optical path lengths within the single-photon coherence length. Here, we provide two-step interferometer stabilization methods employing continuous optical length control and experimentally demonstrate two-photon quantum interference using an actively stabilized 6-km-long fiber-optic Hong-Ou-Mandel interferometer. The two-step active control techniques are applied for measuring highly stable two-photon interference fringes by scanning the optical path-length difference. The obtained two-photon interference visibilities with and without accidental subtraction are found to be approximately 90.7% and 65.4%, respectively.

We report on two-photon quantum interference experiments in the standard telecommunication band. Two identical photons in the 1.5 mm wavelength band were generated in spatially separated modes by a type-I spontaneous parametric down-conversion process, and injected into a fiber-optic Hong-Ou-Mandel interferometer. Two-photon interference patterns of dip and spatial beating in the coincidence counting rate were observed by varying the difference in optical path lengths. The visibilities obtained in the net coincidences were close to the theoretical value of 100%. The raw visibilities were also well above the classical limit.

Stimulated Brillouin scattering in optical fibers can be used to measure strain or temperature in a distributed manner. Brillouin optical time domain analysis (BOTDA) is the most common sensor system based on the Brillouin scattering. This paper presents the experimental analysis of the characteristics of Brillouin gain spectrum (BGS) influenced by the width of launched pulse. Brillouin strain coefficient is also examined for the different pulse widths, which is important to apply a Brillouin scattering-based sensor to a structural health monitoring. Experimental results showed that not only the Brillouin linewidth and gain but also the Brillouin frequency were dependent on the pulse widths.